When the TEMP indicator and the LAMP indicator are illuminated
There are two indicators on the control panel of the projector which give information about the operating condition of the projector. These indicators illuminate or flash to warn you about problems that have occurred inside the projector, so if you notice that one of the indicators is on, turn off the power and check the table below for the cause of the problem.
TEMP indicator
LAMP indicator
TEMP indicator
Indicator | Illuminated (red) | Flashing (red) | Flashing (red) | |
display | (Lamp unit on) | (Lamp unit on) | (Lamp unit off) | |
|
|
|
| |
| The surrounding | The temperature | The surrounding | |
| temperature or the | inside the projector | temperature or the | |
| temperature inside | has become | temperature inside | |
| the projector has | dangerously high, or | the projector has | |
Problem | become unusually | the temperature has | become dangerously | |
| high. | suddenly changed. | high, causing the | |
|
|
| lamp unit to | |
|
|
| automatically shut | |
|
|
| off. | |
|
|
|
| |
Possible | BThe ventilation holes may be covered. |
| ||
BThe ambient temperature in the place of use may be too high. | ||||
cause | BThe air filter may be blocked. |
| ||
|
|
|
| |
| BUncover the ventilation holes. |
| ||
| BSet up the projector in a place where the temperature is | |||
| between 0 °C (32 °F) and 40 °C (104 °F) and the humidity is | |||
| between 20% and 80% (with no condensation). [If you set the | |||
Remedy | “FAN CONTROL” to “HIGH” (page 43), set up the projector in a | |||
place where the temperature is between 0 °C (32 °F) and 35 °C | ||||
| ||||
| (95 °F) and the humidity is between 20% and 80% (with no | |||
| condensation).] |
|
| |
| BDisconnect the mains lead by following the procedure on page | |||
| 24, and then clean the air filter. (Refer to page 49) | |||
|
|
|
| |