PICTURE menu
Remote control | Control panel |
See “Navigating through the menu” on page 32. See “Main menu and
PICTURE MODE
Depending on the projection environment, you can use these preset parameter settings to optimise image projection. Press I H to cycle through the options.
STANDARD | Setting for a general image | |
DYNAMIC | Bright and sharp setting | |
BLACKBOARD | Setting for when projecting on | |
a blackboard | ||
| ||
NATURAL*1 | Reproduces the original color | |
of the image | ||
| ||
CINEMA*2 | Setting for a cinema type | |
movie | ||
| ||
|
|
*1. Selectable when sill image is displayed.
*2. Selectable when moving image is displayed.
NOTE:
•It may take for a while until the image stabilized in the selected mode.
COLOR
You can adjust the color saturation of the projected image. (Available with
LighterDarker
TINT
You can adjust the skin tone in the projected image. (Available with
More More
reddish greenish
SHARPNESS
You can adjust the sharpness of the projected image.
Less | More |
sharp | sharp |
CONTRAST
You can adjust the contrast of the projected image. Adjust the BRIGHTNESS in advance if necessary.
LowerHigher
BRIGHTNESS
You can adjust the brightness of the projected image.
DarkerBrighter
WHITE BALANCE RED
You can adjust the white balance more properly in red color temperature by pressing I H. (Available with RGB/DVI still signals only)
WHITE BALANCE GREEN
You can adjust the white balance more properly in green color temperature by pressing I H. (Available with RGB/DVI still signals only)
WHITE BALANCE BLUE
You can adjust the white balance more properly in blue color temperature by pressing I H. (Available with RGB/DVI still signals only)