Zebra Technologies SL5000r/T5000r manual Appendix a

Zebra Xilll Series

SL5000r/T5000r with ZGL Emulation

Print Width - Width of image to be printed in

QUICK SETUP Menu,

Inches, MM or Dots.

Label Width - Width of image to be printed in Inches or

Printer width dependent.

MM.

Printer width dependent.

Label Length - Printable length of label in

QUICK SETUP Menu,

Inches or MM.

Label Length - Printable length of label in Inches or MM.

Maximum Length - Used to assist in media

CALIBRATE CTRL Menu,

calibration only.

Use Label Length – (Enable*) Uses Label Length value

in QUICK SETUP menu to assist in Auto Calibrate

procedure.

Parallel Comm. -

PARALLEL PORT Menu,

Parallel*

Port Type - IEEE 1284*, Disable or Centronics. NOTE:

Twinax/Coax (option)

Use C/T PORT Menu if Coax/Twinax option installed.

Serial Comm. -

SERIAL PORT Menu,

RS232*, RS422/485 or RS485 multidrop.

Port Type -

RS232*, RS422 or Disable.

Baud - (110 - 57600) 9600*

Baud Rate - (600 - 115200) 9600*

Data Bits - 7-bits* or 8-bits

Word Length 7 or 8*

Parity - (Even*, Odd or None)

Parity - (Even, Odd or None*)

Stop Bits - 1 stop bit* or 2 stop bits

Stop Bits - 1* or 2

Host Handshake -

Data Protocol -

XON/XOFF*, DTR/DSR

XON/XOFF*, ETX/ACK, ACK/NAK, Series 1 Char, Series

Protocol - None*, Zebra or ACK/NAK

2 Char or DTR

Network ID (000* - 999) used for RS-422/

N/A

RS-485 Network only.

Communications -

NOTE: Ptr Defaults to Normal Mode Comm. Hex Dump

Normal Mode* - Prints label image.

(same as Zebra Diagnostic Mode) can be Enabled in

Diagnostics - All data sent from host printed

DIAGNOSTIC Menu.

in ASCII hex chars.

Control Prefix - (00 – FF) Hex 7E*

PPI/ZGL SETUP Menu,

Command Prefix - (1-255)126*.

= Hex 7E*

Format Prefix - (00-FF) Hex 5E*

Label Prefix - (1 to 255) 94*. = Hex 5E*

Delimiter Char. - (00-FF) Hex 2C*

Delimiter - (1 to 255) 44*. = Hex 2C*

ZPL Mode - ZPLII*, ZPL

ZPL Compatibility - ZPL-II*, ZPL-1