Zebra Technologies SL5000r/T5000r manual Pwr Up Auto-Cal Disable*, Enable

Zebra Xilll Series

SL5000r/T5000r with ZGL Emulation

Media Power Up - Media action when the

CALIBRATE CTRL Menu,

printer is powered up.

Feed* - Feeds a label to1st web.

NOTE: SL5000r/T5000r auto feeds a blank label to 1st

Calibration - Recalibrates media when

web (gap) when first print job is sent.

printer is powered up.

Pwr Up Auto-Cal - (Disable*, Enable)

Disable* - No recalibrate at power-up.

Enable - Recalibrates media when printer is powered up.

MEDIA CONTROL Menu,

Length - Determines length of label.

Set Label Length -

Manual* - Label Length set in menu.

Automatic - Auto Calibrate Sensed Distance value used

to set Label Length.

No Motion - Media does not move.

N/A

Head Close - Media action after the print-

N/A (No menu option available).

head is closed.

NOTE: After printhead is closed, SL5000r/T5000r auto

Feed* - Feeds a label to1st web.

feeds a blank label to first web (gap) when first print job is

sent.

Calibration - Recalibrates media.

N/A

Length - Determines length of label.

N/A

No Motion - Media does not move.

N/A

Backfeed - (Default*, after, before, 10 to

N/A Distance back to TOF position of label under

90%, off). Establishes when & how much

printhead is auto controlled by SL5000r/T5000r

label backfeed occurs after a label is cut or

regardless of Paper Feed Shift value when using; Cut,

peeled-off.

Tear-Off, Tear-Off Strip & Peel-Off Media Handling

modes.

Label Top - (-120 to +120 dot rows) +00*.

QUICK SETUP Menu,

Adjusts vertical print position on label.

Ver Image Shift - (-1 to+12.8”) 0.0*”. Adjusts vertical print

position on label.

Or

PPI/ZGL SETUP Menu,

Top Position - (-100 to +100 dots/inch)

0 dots/inch*. Adj vert. position in dot/in.

NOTE: Only avail. in later version SW.

Left Position - (-9999 to +9999)

QUICK SETUP Menu,

0000*. Adjusts image horizontally from left

Hor Image Shift - (-1.0 to +1.0) 0.0”*.

edge of label in dots.

Adjusts image horizontally from left edge of label in

(+) shifts image left. (-) shifts to right.

inches.

(+) shifts image left. (-) shifts image right.

Or

PPI/ZGL SETUP Menu,

Left Position - (-1000 to +1000 dots) 0 dots*. Adjusts

image horiz. in dots.

NOTE: Only avail. in later version SW.

Head Test Count- (0000*-9999) 0000

DIAGNOSTIC Menu,

disables test.

Ptr Media Dist - Inches*, MM.