Zebra Technologies SL5000r/T5000r manual Format Convert None*, 150-300 PPI/ZGL Setup Menu

Zebra Xilll Series

SL5000r/T5000r with ZGL Emulation

Save Settings -

CONFIG CONTROL Menu,

Permanent* - Saves changes even after

Save Config. - Saves changes to 8 cust. Configs. (same

power is turned off.

as Zebra Permanent).

Temporary - Saves until changed again or

NOTE: Changes to all configs. act same as Zebra

until power is turned off.

Temporary mode unless config. saved as 1 of 8 custom

Configs.

Cancel - Cancels all changes since entering

Cancel N/A - Printer auto cancels like Zebra if Config

Config mode.

changes are not saved or if another Config is loaded.

Load Config. - Loads Factory default and 1-8 custom

Load defaults - Loads Factory defaults.

configurations.

Power-Up Config - Selects Factory or 1 of 8 custom

N/A

Configs. as power-up configuration.

Delete Config. - Deletes any of up to 8 saved custom

configurations.

N/A

Print Config. - Prints Factory, Pwr-Up, Current, All, or

custom Configs. 1-8.

N/A

Protect Configs. - When enabled, prevents saving &

overwriting any existing saved custom Config.

N/A

Name Config. 1-8- Permits using up to 15 characters to

name a custom Config.

N/A

Format Convert – (None*, 150-300, 150-

PPI/ZGL SETUP Menu,

600, 200-600, 300-600).

Resolution Mode - Full*, Half

Selects the bitmap scaling factor.

Idle Display (opt)- (Firmware ver, mm/dd/yy

N/A

(24 hr), dd/mm/yy (24 hr), mm/dd/yy (12 hr),

dd/mm/yy (12). Sets LCD display options for

real time clock, if installed.

Set Date (opt)

N/A

mm/dd/yy

dd/mm/yy

Set Time (opt)

N/A

24 hour

12 hour

IP Resolution (opt) -

N/A

Dynamic* - Server selects IP Address.

Permanent - User selects IP Address.

IP Protocols (opt) - (All*, Gleaning only,

N/A

RARP, BOOTP, DHCP).

If Dynamic set in IP Resolution, this selection

determines method(s) that the PrintServer

will receive the IP Address from the server.