Installing the server and connecting the peripheral devices | Standard 1.07 |
To connect the mouse, keyboard, and monitor to the server
1Place the monitor, keyboard, and mouse in the same location as the server.
2Plug the keyboard/mouse dual cable into the PS/2 connector on the SBC card faceplate (see “Rear panel connectors” on page 65).
3Plug the keyboard and mouse into the appropriate connectors on the keyboard/mouse dual cable.
4Plug the monitor into the monitor connector on the SBC card. Tighten the screws on the connector.
5Ensure that a
6Connect the power cord to the monitor and plug the other end into a wall receptacle or power bar.
Note: Ensure that the power source is consistent with the SBC for all ancillary equipment.
7Turn on the monitor.
To connect the modem to the server
1Ensure that the modem AC power cord is not plugged in.
2Connect the large
3Connect the
4Connect one end of the telephone cable to the modem
5Connect the other end of the telephone cable to the
66 | CallPilot |