Nortel Networks 1002rp manual Connecting the server to the Elan, To connect the server to the Elan

Installing the server and connecting the peripheral devices Standard 1.07

Connecting the server to the ELAN

Introduction

ATTENTION
	This section applies only if the 1002rp server connects
	to a Meridian 1 switch or Succession 1000 system.

Connect the CallPilot server to the Meridian 1 switch or Succession 1000 system using the ELAN.

ATTENTION
	For important considerations about using the ELAN in
	your network, see the Planning and Engineering Guide
	(555-7101-101).
ATTENTION
	To comply with EMC radiation requirements, a Class A
	hub must be located 10 m (33 ft.) away from the 1002rp
	server. Shielded Ethernet cables must be used.

Media Access Control address

The Media Access Control (MAC) address is a unique number assigned to network cards and controllers. The procedure below asks you to record the ELAN MAC address. The MAC address is recorded on a label affixed to the back of the chassis.

To connect the server to the ELAN

1See the diagram on page 65 to locate the ELAN Ethernet connector.

2Locate the MAC address label on the back of the chassis that identifies the ELAN controller MAC address.

68 CallPilot