American Power Conversion MX06 50, MX06 100 user manual Battery and Load Power up

Page 20

5)Use a Digital voltmeter to measure the system voltage using the “RTN” (+) and ”-NEG V” (-) test points on the front panel. The voltage is set at the factory for –54.0 V dc. Use the “V ADJ” potentiometer to set the voltage to the desired level.

3.11.Battery and Load Power up

After the initial checkout has been performed, the following steps are followed to complete the system power up procedure.

1)Turn on the external circuit breaker from the battery to the power plant.

2)Load circuit protection may now be enabled as required.

MX06 Power Plant User’s Manual

Page 16

Image 20

Contents VDC Power Systems Table of Contents APC Worldwide Customer Support Limited Product Warranty Revision History RevisionSafety First General PrecautionsIntroduction General InformationPort How to Use This Manual Installation Mechanical InstallationUnpacking Equipment Room / LocationAC Power Connections VentilationConnecting the Battery Cables Battery ConnectionsPlanning the Battery installation Battery LVD Connection Multiple Battery StringsBattery LVD Battery Temperature Probe Installation DC System GroundingGMT Fuse Installation Load Protection InstallationCircuit Breaker Installation Circuit Breaker Protected Load Connections 30 or 60 Amps Load ConnectionsCable Size Considerations Relay Output Connections Input / Output Connections GMT Fuse protected Load Connections Relay J2 Connector Output Relay Notes Designations External Alarm Input ConnectionsRectifier Module Installation Initial Power-Up and CheckoutBattery and Load Power up Technical Description Rectifier ManagementAlarm Functions System ManagementControl Functions DisplaysBattery Management Battery ChargingBattery Temperature Compensation Load ManagementBattery Low Voltage Disconnect MX06 Voltage Adjustments OperationDescription MX06 OperationAlarm No Setting NC Setting Major Minor Factory MX06-50 Configuration SettingsMX06 External Alarm Input Configuration MX06-50 Rectifier Configuration MX06-50 Programmable AlarmsAlarm Major Minor No Alarm FactoryMX06-100 Rectifier Configuration MX06-100 Configuration SettingsMX06-50 Temperature Probe Selection MX06-100 Programmable Alarms MX06-100 Temperature Probe SelectionSpecifications MX06 50 Power SystemAC Input TWF0500H5401 RectifierMX06 100 Power System DC OutputVDC MX06 Controller Controls and IndicatorsMechanical Environmental Magnum VS 50 Power SystemMagnum VS 100 Power System Compliance EMCAPC Worldwide Customer Support Limited Product Warranty