American Power Conversion MX06 50, MX06 100 user manual MX06-100 Configuration Settings

MX06-50 Temperature Probe Selection

Temperature compensation can be configured for either a Fahrenheit or Celsius probe by the use of configuration jumpers on pin header J4 shown in Figure 5.3-1. The MX06-50 is factory set for Fahrenheit operation, with jumpers on all position of J4.

5.4. MX06-100 Configuration Settings

The control card for the MX06-50 is different than the control card for the MX06-100 due to increased number of rectifiers in the MX06-100. The control card for the MX06 is the 0P9172 and for the MX06-100, the control card is the 0P9745. This section will deal with configurations applicable to the MX06-100 only.

						GND			V-ADJ
					E1				E8
								BATT ALM GMT ALM
								J4	J7
		Factory Set. Do not touch.						J5	J8
								J6	J9
								(SEE MANUAL)
J1	K1	RECT SELECT
		S2		ON: RECTIFIER NOT INSTALLED
				OFF: RECTIFIER INSTALLED
			1
				10
		RECT NUMBER
K4		K2	K3
		R105		R106		R102		R103	R104
		E12	DISCON LEV ADJ			E9	L V ALARM
			E13					E10	E11
		RECON LEV ADJ				H V ALARM			VLV ALARM

NO\NC
INPUT	DC GOOD
USER ALM	MAJOR
1
	MINOR
8	LOW V

MAJ/MIN

SELECTVLV

OFFON

E101 +BAT

E102 -BAT

R101 V ADJ

Figure 5.4-1 MX06-100 Controller Layout

MX06-100 Rectifier Configuration

The system Controller Board must know if a rectifier is present for each of the five slots. This is done by the properly setting the dipswitch S2 (“RECT PRESENT”) on the Controller Board. If a rectifier is not present in a given slot, the corresponding switch position must be set to the “ON” condition. The ON direction is labeled on the body of the dipswitch. Figure 5.4-1 locates switch S2 on the PC board.

MX06 Power Plant User’s Manual Page 24