American Power Conversion MX06 100, MX06 50 user manual MX06-100 Programmable Alarms

MX06-100 Programmable Alarms

The GMT alarm, and the battery circuit breaker alarm can each be programmed to either MAJOR or MINOR alarm priority. A three-pin jumper header is used for each alarm in the manner shown in Figure 13. Figure 12 locates the jumpers on the PC board. If no jumper is in place, then no alarm will be reported. Do not touch any jumpers, other than J6 and J9, as they are factory set for the configuration that you order.

1 2 3 1 2 3

	MAJOR			MINOR
		Figure 5.4-2 MX06-100 Jumper Programming
Alarm		Jumper	Major	Minor	No Alarm	Factory
		Designator	Setting	Setting	Output	Setting
GMT		J9	Pins	Pins	No	Major
Alarm			2 and 3	1 and 2	Jumper
Battery			Pins	Pins	No
Breaker		J6				Major
			2 and 3	1 and 2	Jumper
Alarm
		Figure 5.4-3 MX06-100 Alarm Jumpers

MX06-100 Temperature Probe Selection

Temperature compensation can be configured for either a Fahrenheit or Celsius probe by the use of configuration jumpers on pin header J3 shown in Figure 5.4-1. The MX06-100 is factory set for Fahrenheit operation, with jumpers on all position of J3.

MX06 Power Plant User’s Manual Page 25