AC International SV01B, V0100 operating instructions Advanced Setup Parameters, Code

Commissioning

4.5.3Advanced Setup Parameters

Code		Possible Settings					IMPORTANT
No.	Name	Default Selection
	Speed at	0.0	-999.0	{Hz}	1000	f
	Minimum Signal
						P161
	Speed at	60.0	-999.0	{Hz}	1000	0V	10V	ref
	Maximum Signal
						(4mA)	(20mA)
						P160
								V0111

Note

• P160 sets the output frequency at 0% analog input

•P161 sets the output frequency at 100% analog input

•P160 or P161 < 0.0 Hz: For scaling purposes only; does not indicate opposite direction!

•P160 > P161: Drive will react inversely to analog input signal

	Analog Input	0.01	0.00		{s}	10.00	Adjusts the filter on the analog inputs
	Filter						(TB-5 and TB-25) to reduce the effect
							of signal noise
	TB-25 Loss	0	0	No Action			• Selects the reaction to a loss of the
	Action		1	Fault			4-20 mA signal at TB-25.
							• Signal is considered lost if it falls
			2	Go to Preset when TB-25 is:
							below 2 mA
				Speed reference:		P137	• Digital outputs can also indicate a
				PID feedback source: P137			loss of 4-20 mA signal; see P140,
				PID setpoint reference: P233			P142
				Torque reference:		P333
	Carrier	1	0	4 kHz			• As carrier frequency is increased,
	Frequency		1	6 kHz			motor noise is decreased
							• Observe derating in Section 2.2
			2	8 kHz
							• Automatic shift to 4 kHz at 120%
			3	10 kHz			load
(1)	Base Frequency	60.0	10.0		{Hz}	1500
	Fixed Boost		0.0		{%}	30.0
							V0112
			Note
			• P167 = rated motor frequency for standard applications
			• P168 default setting depends on drive rating
	Accel Boost	0.0	0.0		{%}	20.0	Accel Boost is only active during
							acceleration
(1) Any changes to this parameter will not take effect until the drive is stopped

22 ENGLISH