ADJUSTING THE PRINTER SETTINGS
4. Display the required setting for this feature.
Press 
or 
to scroll through the possible set- tings until you see the one that you want. Hold down 
or 
if you wish to scroll quickly through the possible settings.
The 
icon to the left of "STD" indicates that STD is a possible setting, but it is not the current setting. An 
icon would indicate that this is the current setting.
Note: If you want to return to the main menu at any time without changing a setting, press 
until you get back to the main menu.
5. Store the displayed setting.
When you see the setting that you want, press 
.
The new setting is stored, and you are returned to the main menu for Level 1. The new setting is displayed.
If you wish, you can scroll through the main menu with the 
or 
key to change an- other setting. If you have finished changing settings, go on to step 6.
Note: You cannot move directly to a setting that is in a different Selectype level. For example, you cannot directly access a Level 2 feature while you are in Level 1. You must return to printer "Ready" mode, then enter Selectype Level 2.
6. Go back to printer "Ready" mode.
Press 
as many times as necessary until you see the following.
Then press 
once more to go to printer "Ready" mode.
7. Return the machine to standby mode for fax communication.
To return the fax machine to standby mode, press
Function
.
Also, if you do not touch the machine for 4 minutes, the machine returns to standby mode automatically.
Note: If you press Function while still in the middle of a procedure, your setting will not be stored (unless you pressed 
(SET) first). However, when you enter printer setup mode again, the display will take you immediately to where you were just before you left it. Also you may have to reset the machine on/off line.
25