ADJUSTING THE PRINTER SETTINGS
SELECTYPE LEVEL 1 FEATURES
How to Enter Selectype Level 1
The procedure for entering Level 1 is as follows.
If you have set your printer up in Autosense
1. Make sure that the printer is in printer "Ready" mode.
Note: If the machine is in fax standby mode, press Function 
3 
5 
Yes
.
2.Press 
until the display is as shown on the right. Then release the key immediately.
Note: If you press the 
key for too long, you will enter Level 2 mode. If so, press 
until you get to standby mode, then try again.
If you have set the printer up in Individual
Either:
❐Press 
to select the serial channel. Go to step 3.
❐Press 
to select the parallel channel. Go to step 3.
❐Press 
to leave Level 1.
3.The display soon changes to show one of the Level 1 menu features. An example is shown on the right.
4.Press 
or 
until the feature that you want is displayed.
If you change a Level 1 setting and want to keep it permanently (that is, if you do not want the machine to go back to the old setting when you switch the power off), save your current settings as a macro with the SAVE MACRO routine (see page 31), then make that macro the
Each of the Level 1 features is explained in the following pages. For a concise list of the features that are available in level 1, see page 21.
26