Epson 60 manual Solving Problems, Status and Error Messages, Change PCU, Char Creating

SOLVING PROBLEMS

STATUS AND ERROR MESSAGES

While the printer is being used, messages on the display panel indicate the status of the machine and alert the user to any errors that may occur. This section gives an al - phabetical list of these messages, and explains how to clear any associated problems.

Note
If you see the	indicator flashing, first correct the problem, then press the	key
to clear the error. (However, if the AUTO CONT. option is set to ON (see page		41),
some errors clear automatically, even though the problem remains. Therefore, in
most cases, it is best to leave AUTO CONT. off to avoid the possibility of
damaging your printer.)
The error messages are described below.
ADD MEMORY FOR CH-x
There is not enough memory for channel x. Either:

❐Decrease the RX-BUFFER SIZE setting (see page 37).

❐Change the CH setting to AUTOSENSE (see page 38).

❐Adjust the memory distribution in the INDIVIDUAL setting of the CH function (see page 38).

❐Add printer memory (see page 10).

CHANGE PCU

Reset the PCU counter (see page 43). Do not change the master unit.

CHAR CREATING

The printer is creating characters. Please wait.

COPY END x/y

Multi-copy printing was canceled. ’x’ represents the current page number, and ’y’ shows the number of copies currently set in the COPIES setting (see page 27).

COVER OPEN PCU xxxxxx

The printer cover is open, or the toner cartridge or master unit is not installed. Close the cover or install the missing component. See the fax machine’s Operator’s Manual for how to install a toner cartridge.

’xxxxxx’ shows the current PCU counter value (see page 43). You can reset this counter by pressing the or key while this message is displayed.

DATA: {x} {mode}

The printer has received data but is not yet printing or is off line. To resume printing, press if the printer is off line, or press to print the data. ’x’ shows the current chan - nel, and ’mode’ shows the current printer mode.

44