Epson 60 manual System Config, Full Print

ADJUSTING THE PRINTER SETTINGS

SYSTEM CONFIG.

This is another menu of features within Level 1. The features are as follows.

❐Memory-related features: FULL PRINT, MEMORY LEFT

❐Printer offset adjustments: T-OFFSET, L-OFFSET

❐Macros: LOAD MACRO, SAVE MACRO, DELETE MACRO, POWERON MACRO

To enter System Config. mode, do the following.

1. Enter Level 1 mode (see page 26).

2.Press or until SYSTEM CONFIG is dis - played.

-FULL PRINT -

This setting specifies how much of your printer’s memory is set aside for page composi - tion.

The default setting of 0 is enough for most uses of the printer. However, if you are print - ing complex pages, you may need to increase the setting. If you ever see the SET FULL PRINT error message on the display, you will have to increase the setting.

For example, if you set a value of 5, you are allocating 5 x 20 KB = 100 KB.

The amount of memory that you set aside with this feature will not be available for any other purpose. So it is best to leave the setting at 0 until you see a SET FULL PRINT message. Then increase the setting in small increments until the error does not appear.

After increasing the setting, you may see INSUFF. MEMORY or PAGE BUFFER FULL next time you try to print. In this case, you must either install an optional printer mem - ory kit or try to make do with a lower setting for FULL PRINT.

1. Enter SYSTEM CONFIG mode (see above).

2. , then or until FULL PRINT is dis - played.

3.

4.Press or until the required setting is dis - played.

5. Store the displayed setting:

6.

29