Epson 60 manual Appendix B. HP Emulation Mode, HP Emulation Modevs HP Laserjet, Printable Area

APPENDIX B. HP EMULATION MODE

This section informs you about using your printer’s HP emulation mode. It describes the unique features of your printer’s HP emulation as well as the differences between your printer’s HP emulation and printing with an actual HP LaserJet printer.

HP EMULATION MODEVS HP LASERJET III

Your printer differs slightly from a HP LaserJet III because the two printers use different technologies. The differences in printing are explained below.

	Your Printer	HP LaserJet Series III
Input paper supply	Refer to the specifications for	200 sheets
Paper size	the base fax machine.	Letter, Legal, A4, Executive,
		Monarch 7-3/4
		Commercial 10, DL, C5
Resident fonts	Bitmap: 14	Bitmap: 10
	Scalable: 13	Scalable: 8
Maximum no. of fonts per page	Depends on the amount of memory
Page buffer mode	Built-in	Not available

Printable Area

The size of the printable area for the HP LaserJet se - ries III and this printer is the same. The maximum number of characters per line is also the same. How - ever, the position of the printout on the page may not be exactly the same as for output from a HP Laser - Jet series III.

If you wish to match your printing to the output pro - duced on a HP LaserJet series III printer, use the T- OFFSET and L-OFFSET controls (see page 30) to make fine adjustments to the printing start position.

However, the offset controls can move the data out - side the printable area, so some data may be miss - ing.

The printable areas for various paper sizes are shown in the following table.

Portrait

Paper feed

Paper Size	l	x	r	t	y	b
A4	50	2380	50	50	3407	50
Letter		2450			3200
Legal		2450			4100

Units: Dots at 300 dpi

B-1