Toshiba BSX5TTS25QMR, BSX5TTS22QMR, B-SX5T SERIES owner manual Procedure before Operation

2. PRINTER SETUP ENGLISH VERSION EO1-33036

2.2 Procedure before Operation

2.2Procedure before Operation

NOTE:

To communicate with the host computer, one of the following cables is required.

(1)RS-232C cable: 25 pins

(2)Centronics cable: 36 pins

(3)USB: B plug (Option)

(4)LAN: 10 Base-T or 100 Base-TX (Option)

This section describes the outline of the printer setup.

1.Unpack the accessories and printer from the box.

2.Refer to Safety Precautions in this manual and set up the printer at a proper location.

3.Fit the Fan Filter to the printer. (Refer to Section 2.3.)

4.The host computer must have a serial, Centronics parallel, USB or LAN port. (Refer to Section 2.4.)

5.Be sure to insert the power cord plug into an AC outlet. (Refer to Section 2.5.)

6.Load the media. (Refer to Section 2.7.)

7.Adjust the position of the Feed Gap Sensor or Black Mark Sensor depending on the media being used. (Refer to Section 2.7.)

8.Load the ribbon. (Refer to Section 2.8.)

9.Turn the power ON. (Refer to Section 2.6.)

10.Perform a test print. (Refer to Section 2.10.)

11.Install the Printer Drivers. (Refer to the Printer Driver Manual.)

2.3 Fitting the Fan Filter When installing the printer, it is important to ensure that the Fan Filter is

attached before using the printer.

The Fan Filter consists of 2 parts:

(1)Filter Pad

(2)Filter Retainer

To fit the Fan Filter, put the Filter Pad inside the Filter Retainer and simply press into place as shown in the diagram below, ensuring connecting pins are aligned with the connecting holes.

Filter Pad

Snap On

Filter Retainer

Snap On

E2- 2