Toshiba B-SX5T SERIES, BSX5TTS25QMR Do not over-tighten the Locking Ring of the Supply Holder

Page 17

2. PRINTER SETUP

ENGLISH VERSION EO1-33036

2.7 Loading the Media

2.7Loading the Media (Cont.)

NOTE:

Do not over-tighten the Locking Ring of the Supply Holder.

5.Put the media on the Supply Shaft.

6.Pass the media around the Damper, then pull the media towards the front of the printer.

7.Align the projection of the Supply Holder with the groove of the Supply Shaft, and push the Supply Holder against the media until the media is held firmly in place. This will centre the media automatically.

Then turn the Locking Ring clockwise to secure the Supply Holder.

Groove Damper

Supply Holder

Projection

	Media			Supply Shaft			Locking Ring
							Locking Ring

In case of a label rolled with						In case of a label rolled with
the print side facing inside.						the print side facing outside.

MediaDamper

8.Place the media between the Media Guides, adjust the Media Guides to the media width, and tighten the Locking Screw.

9.Check that the media path through the printer is straight. The media should be centred under the Print Head.

Media Guide

Print Head

Supply Holder

Locking Screw	Media	Media Guide

E2- 7

Image 17

Contents SX5T Series Vorsicht CE Compliance for EU onlyWkhsoxj Request Regarding Maintenance PrecautionsTable of Contents EA2-1 EA1-1EA3-1 EA4-1Unpacking Introduction FeaturesProduct Overview Accessories Appearance DimensionsFront View Rear ViewInterior Operation PanelPrecautions Printer SetupProcedure before Operation Gori Connecting the Cables to Your PrinterConnecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Parts, be sure to load Loading the MediaDo not over-tighten the Locking Ring of the Supply Holder Setting the Black Mark Sensor position Setting the Feed Gap Sensor positionSTANDARD/PEEL OFF position Batch modeStrip mode Adjustment Build-in rewinder modeCut mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards Test Print 3517$5&2 Printer’s power OFF then back to on and check that the LCD Sample of the bar code test print label Operation Panel On Line ModeOperation ResetDump Mode Print Head/Platen/ Sensors MaintenanceCleaning Covers and Panels Optional Cutter Module Care/Handling of the Media and RibbonError Messages TroubleshootingError Messages Problems/Causes Solutions Restart keyPossible Problems Causes Solutions Possible ProblemsError Messages Problems/Cause Solutions Do not use any tool that may damage the Print Head Removing Jammed MediaThreshold setting procedure Threshold SettingModel Appendix 1 SpecificationsA1.1 Printer A1.3 Media A1.2 OptionsA1.3.1 Media Type LabelLabel A1.3.2 Detection Area of the Transmissive SensorTag paper with square holes A1.3.3 Detection Area of the Reflective SensorA1.3.4 Effective Print Area Figure below shows the effective print area on the media A1.4 RibbonAppendix 2 Messages and Leds Symbols in the message67$9$ „Interface Cables Appendix 3 InterfaceAppendix 4 Print Samples JAN13, EAN13 Interleaved 2 CODE39 StandardEAN13+2 digits EAN13+5 digitsIndustrial 2 UPC-A+5 digitsBar code GlossariesUSB Universal Serial Bus Print head elementIndex Index Page Page EO1-33036B

Related manuals

Manual 120 pages 3.28 Kb