Toshiba B-SX5T SERIES, BSX5TTS25QMR, BSX5TTS22QMR owner manual Build-in rewinder mode, Adjustment

2. PRINTER SETUP ENGLISH VERSION EO1-33036

2.7 Loading the Media

2.7Loading the Media (Cont.)

NOTE:

Be sure to set the Selection Switch to REWINDER position.

Build-in rewinder mode

When the Rewinder Guide Plate is attached, the Take-up Spool can be used as a Built-in Rewinder to take up the printed media.

(1) Remove the two Black Screws to detach the Front Plate.

Front Plate

Black Screw

(2)Attach the Rewinder Guide Plate to the Strip Plate with the SMW- 4x8 sems screws.

Rewinder

Guide Plate

SMW-4x8 Screw

ADJUSTMENT:

If the media skews when using the Built-in Rewinder, turn the Adjustment Knob of the Rewinder Guide Plate to correct the media feed. Clockwise turn moves the Rewinder Guide Plate forward and counter-clockwise moves it backward.

When the media skews to the right:

Loosen the SM-4x8 screw, turn the Adjustment Knob clockwise, and then tighten the SM-4x8 screw when the Rewinder Guide Plate is positioned correctly.

When the media skews to the left: Loosen the SM-4x8 screw, turn the Adjustment Knob counter- clockwise, and tighten the SM- 4x8 screw when the Rewinder Guide Plate is positioned correctly.

(3)Insert the media under the Rewinder Guide Plate.

(4)Wind the media onto the Take-up Spool and fix it in position with the Take-up Clip.

(5)Rotate the Take-up Spool counterclockwise a few times to remove any slack in the media.

(6)Set the Selection Switch mounted on the Rewinder Assembly to REWINDER position.

Adjustment Knob

SM-4x8 Screw

Rewinder

Guide Plate

E2-10