Toshiba BSX5TTS25QMR, BSX5TTS22QMR, B-SX5T SERIES owner manual EA1-1, EA2-1, EA3-1, EA4-1

Page 6

ENGLISH VERSION EO1-33036

APPENDIX 1 SPECIFICATIONS

EA1-1

A1.1

Printer

EA1-1

A1.2

Options

EA1-2

A1.3

Media

EA1-2

 

A1.3.1 Media Type

EA1-2

 

A1.3.2 Detection Area of the Transmissive Sensor

EA1-3

 

A1.3.3 Detection Area of the Reflective Sensor

EA1-4

 

A1.3.4 Effective Print Area

EA1-4

A1.4

Ribbon

EA1-5

APPENDIX 2 MESSAGES AND LEDS

EA2-1

APPENDIX 3 INTERFACE

EA3-1

APPENDIX 4 PRINT SAMPLES

EA4-1

GLOSSARIES

 

INDEX

 

 

WARNING!

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

CAUTION!

1.This manual may not be copied in whole or in part without prior written permission of TOSHIBA TEC.

2.The contents of this manual may be changed without notification.

3.Please refer to your local Authorised Service representative with regard to any queries you may have in this manual.

Image 6
Contents SX5T Series CE Compliance for EU only VorsichtWkhsoxj Precautions Request Regarding MaintenanceTable of Contents EA3-1 EA1-1EA2-1 EA4-1Introduction Features Product OverviewUnpacking Accessories Front View DimensionsAppearance Rear ViewOperation Panel InteriorPrinter Setup PrecautionsProcedure before Operation Connecting the Cables to Your Printer GoriConnecting the Power Cord Turning the Printer Turning on the PrinterTurning OFF the Printer Loading the Media Parts, be sure to loadDo not over-tighten the Locking Ring of the Supply Holder Setting the Feed Gap Sensor position Setting the Black Mark Sensor positionBatch mode Strip modeSTANDARD/PEEL OFF position Build-in rewinder mode AdjustmentCut mode Loading the Ribbon Auto Ribbon Saving Mode Pcmcia Cards 3517 Test Print$5&2 Printer’s power OFF then back to on and check that the LCD Sample of the bar code test print label On Line Mode Operation PanelReset OperationDump Mode Maintenance CleaningPrint Head/Platen/ Sensors Covers and Panels Care/Handling of the Media and Ribbon Optional Cutter ModuleError Messages Problems/Causes Solutions TroubleshootingError Messages Restart keyPossible Problems Error Messages Problems/Cause SolutionsPossible Problems Causes Solutions Removing Jammed Media Do not use any tool that may damage the Print HeadThreshold Setting Threshold setting procedureAppendix 1 Specifications A1.1 PrinterModel A1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor LabelA1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaTag paper with square holes A1.4 Ribbon Figure below shows the effective print area on the mediaSymbols in the message Appendix 2 Messages and Leds67$9$ Appendix 3 Interface „Interface CablesAppendix 4 Print Samples EAN13+2 digits Interleaved 2 CODE39 StandardJAN13, EAN13 EAN13+5 digitsUPC-A+5 digits Industrial 2Glossaries Bar codePrint head element USB Universal Serial BusIndex Index Page Page EO1-33036B
Related manuals
Manual 120 pages 3.28 Kb