Toshiba BSX5TTS25QMR A1.3.3 Detection Area of the Reflective Sensor, A1.3.4 Effective Print Area

APPENDIX 1 SPECIFICATIONS ENGLISH VERSION EO1-33036

A1.3 Media

A1.3.2 Detection Area of the Transmissive Sensor (Cont.)

<Tag paper with square holes>

		Centre of media
Sensor position			Print side
Min. 2.0 mm			Square holes
			(Round holes are not acceptable.)
	Min. 12 mm		Media feed direction

Sensor is movable within this range.

NOTE:

Round holes are not acceptable.

A1.3.3 Detection Area of the Reflective Sensor

The Reflective Sensor is movable from the centre to the left edge of media.

The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. The Reflective Sensor should be aligned with the centre of the Black Mark.

Sensor should be positioned at the centre of the black mark.

Min. 2.0 mm

Min. 12 mm

Centre of media

Detecting the black marks on the back.

Media feed direction

Sensor is movable within this range.

A1.3.4 Effective Print Area

The figure below illustrates the relation between the head effective print width and media width.

Out of print range Out of print range

6.0 mm

128.0mm±0.2

(Head Effective Print Range)

6.0 mm

140 mm (Max. media width)

EA1- 4