2. PRINTER SETUP
ENGLISH VERSION
2.7 Loading the Media
2.7 Loading the Media
WARNING!
1.Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc. being drawn into the moving parts, be sure to load the media once the printer has stopped moving completely.
2.To avoid injury, be careful not to trap your fingers while opening or closing the Top Cover.
CAUTION!
Be careful not to touch the Print Head Element when opening the Top Cover.
Failure to do this may cause missing dots by static electricity or other print quality problems.
This section describes how to load a media in the printer. This printer accepts label rolls, tag rolls, and fanfold paper stocks. Please use TOSHIBA TEC approved media.
NOTES:
1.Please perform a media sensor calibration whenever you change the media type.
2.The size of the media which can be loaded inside the printer is as follows:
Outer roll diameter: Max. 127mm (5”)
Inner core diameter: 25.4 (1”) mm or 38.1 mm (1.5”) When the outer roll diameter exceeds 127 mm or the inner core diameter exceeds 38.1 mm, an optional External Media Roll Hanger is required. For details, refer to the Installation Guide for the External Media Roll Hanger.
3.Some media rolls are wound inside and the others are wound outside. (See the diagram below.) Both types of media roll should be loaded so that the print side faces up.
Outside wound |
| Inside wound |
| ||
|
|
|
1.Press down the Top Cover Release Button to unlock the Top Cover, then fully open the Top Cover.
Top Cover
Top Cover Release
Button
E2- 7