2. PRINTER SETUP
ENGLISH VERSION
2.7 Loading the Media
2.7Loading the Media (Cont.)
2.Slide the Media Holder Lock Switch to the Unlock (▲) side to release the Media Holders.
Media Holder Lock Switch
NOTE: Media path
Feed Gap Sensor
Platen
Black mark sensor
NOTES:
1.Refer to the Supply Path Label attached inside of the Top Cover.
2.Make sure that the print side faces up.
3.Cut the leading edge of the media straight with scissors.
NOTE:
Do not forcibly move the Media Guides by hand, as doing so may break the Media Guides.
3.Open the Media Holders.
Media Holder 
Media Holder
4.Place a media roll between the Media Holders so that the media is fed with the print side facing up. Fit the projection of the Media Holders into the core. Make sure that the projection of the both Media Holders is engaged with the core firmly.
Media
Media Holder
Media Holder
5.Turn the Media Guide Adjustment Dial in the arrow indicating direction to move the Media Guides outward.
Media Guide
Adjustment Dial
E2- 8