2. PRINTER SETUP
ENGLISH VERSION
2.7 Loading the Media
2.7Loading the Media (Cont.)
WARNING!
HAZARDOUS MOVING PARTS KEEP FINGERS AND OTHER BODY PARTS AWAY
The cutter is sharp, so care must be taken not to injure yourself when handling the cutter.
CAUTION!
1.Be sure to cut the backing paper of the label. Cutting labels will cause the glue to stick to the cutter which may affect the cutter quality and shorten the cutter life.
2.Use of tag paper of which thickness exceeds the specified value may affect the cutter life.
Cut mode (Option):
When the Cutter is installed, the media is automatically cut.
After loading the media as described on the previous pages, insert the leading edge of the media through the Media Outlet of the Cutter Cover.
Cutter Cover
Media Outlet 
NOTE:
When placing fanfold paper stock on the rear of the printer, the following care should be taken.
1.Face the print surface up.
2.The fanfold paper stock is parallel to and level with the fanfold paper slot.
3.Interface cables do not interfere with the feed of fanfold paper.
How to Load Fanfold Paper Stock
1.Place the fanfold paper stock on the rear of the printer, and insert the leading edge of the paper into the Fanfold Paper Slot.
Fanfold Paper Stock
Fanfold Paper Slot
2.Refer to the previous pages to feed the fanfold paper through the printer until it extends past the media outlet.