Toshiba B-EV4D owner manual Platen/Sensors, Cover, Media Housing

Page 30

3. MAINTENANCE

ENGLISH VERSION EO1-33088

3.1 Cleaning

3.1.2 Platen/Sensors	1.	Wipe the Platen with a soft cloth moistened with absolute ethyl
	2.	alcohol.
	2.	Remove dust or paper particles from wipe the Black Mark Sensor,
		Feed Gap Sensor, and Cover Open Sensor with a dry soft cloth.

Feed Gap Sensor

Platen

Black Mark Sensor

Cover Open Sensor

3.1.3 Cover

CAUTION!

Do not use any volatile solvents including thinner and benzene, as this may cause discoloration or distortion of the cover.

Wipe the Cover with a dry soft cloth. Wipe off dirt with a soft cloth slightly moistened with mild detergent solution.

3.1.4 Media Housing	Wipe the media housing with a dry soft cloth. Wipe off dirt with a soft
	cloth slightly moistened with mild detergent solution.

E3- 2

Image 30

Contents EV4D Series CE Compliance for EU only VorsichtSafety Summary Meanings of Each SymbolPrecautions Request Regarding MaintenanceTable of Contents EA2-1 For EU onlyIntroduction Features Unpacking Accessories Product OverviewWhen purchasing the power cord SVT H05VV-FDimensions Front View AppearanceRear View Interior Button and Indicator Lamp Printer statusPrinter Setup PrecautionsProcedure before Operation Turning the PrinterTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord Opening/Closing the Top Cover To open the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode Strip mode Option How to set the mediaHow to Load Fanfold Paper Stock Cut mode OptionExternal Media Roll Hanger Option Test, and Dump Mode different type Utilities Media SensorMedia Sensor Calibration Self Print Test and Dump Mode Print test label sampleE2-16 How to Use an SD Card „ Inserting an SD Card„ Removing an SD Card Maintenance CleaningPrint Head Media Housing Platen/SensorsCover Care/Handling of the Media OptionTroubleshooting Troubleshooting GuideColor Status Cause Solutions Status LampRemoving Jammed Media Appendix 1 Specifications A1.1 PrinterEV4D-TS14-QM-R A1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaBlack Mark Figure below shows the effective print area on the media Appendix 2 Interface Interface CablesGlossaries Bar codeSupply EO1-33088C