Toshiba B-EV4D owner manual Removing Jammed Media

Page 34

4. TROUBLESHOOTING

ENGLISH VERSION EO1-33088

4.3 Removing Jammed Media

Flashing speed of the LED

Status	Flashing interval
Flashing slowly	1 sec.
Flashing at medium speed	0.5 sec.
Flashing fast	0.2 sec.

4.3 Removing Jammed Media

This section describes in detail how to remove jammed media from the printer.

CAUTION!

Do not use any tool that may damage the print head.

1.Turn the power off.

2.Open the Top Cover and remove the media roll.

3.Remove the jammed media from the printer. DO NOT USE any sharp implements or tools as these could damage the printer.

4.Clean the Print Head and Platen, then remove any further dust or foreign substances.

5.Load the media again, and close the Top Cover.

E4- 3

Image 34

Contents EV4D Series CE Compliance for EU only VorsichtSafety Summary Meanings of Each SymbolPrecautions Request Regarding MaintenanceTable of Contents EA2-1 For EU onlyIntroduction Features Unpacking Accessories Product OverviewWhen purchasing the power cord SVT H05VV-FAppearance Dimensions Front ViewRear View Interior Button and Indicator Lamp Printer statusPrinter Setup PrecautionsTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode Strip mode Option How to set the mediaHow to Load Fanfold Paper Stock Cut mode OptionExternal Media Roll Hanger Option Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Self Print Test and Dump Mode Print test label sampleE2-16 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Care/Handling of the Media OptionTroubleshooting Troubleshooting GuideColor Status Cause Solutions Status LampRemoving Jammed Media Appendix 1 Specifications A1.1 PrinterEV4D-TS14-QM-R A1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorBlack Mark Figure below shows the effective print area on the media Appendix 2 Interface Interface CablesGlossaries Bar codeSupply EO1-33088C