Toshiba B-EV4D owner manual Strip mode Option, How to set the media

Page 22

2. PRINTER SETUP

ENGLISH VERSION EO1-33088

2.7 Loading the Media

2.7Loading the Media (Cont.)

NOTES:

1.When issuing labels without removing them from the backing paper, it is not necessary to pass the media through the Strip Block.

2.When the media is correctly set, the backing paper is supposed to be pinched by the Platen and the Strip Feed Roller as shown below.

Strip Plate

Label

Strip Feed Roller

Platen

Backing Paper

3.If the peel-off issue is performed under intense light, the strip sensor may not correctly detect the presence of a printed label on the strip shaft. In this case, reduce the intensity of the light or fit the Shade Plate to the Strip Block as shown in the figure.

Strip mode (Option):

When issued in the strip mode, labels are automatically removed from the backing paper each time a label is printed.

How to set the media

When issuing labels in the strip mode, set the label in the following procedure:

1.Load the media as described on the previous pages.

2.Open the Strip Block by pulling it out.

Strip Block

3.Remove enough labels from the leading edge of the media to leave 20 cm of backing paper free, and insert the top edge of the backing paper into the media slot in the Strip Block.

Shade Plate

4.Close the Strip Block and Top Cover.

E2-11

Image 22
Contents EV4D Series CE Compliance for EU only VorsichtSafety Summary Meanings of Each SymbolPrecautions Request Regarding MaintenanceTable of Contents EA2-1 For EU onlyIntroduction Features Unpacking Accessories Product OverviewWhen purchasing the power cord SVT H05VV-FAppearance Dimensions Front ViewRear View Interior Button and Indicator Lamp Printer statusPrinter Setup PrecautionsTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode Strip mode Option How to set the mediaHow to Load Fanfold Paper Stock Cut mode OptionExternal Media Roll Hanger Option Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Self Print Test and Dump Mode Print test label sampleE2-16 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Care/Handling of the Media OptionTroubleshooting Troubleshooting GuideColor Status Cause Solutions Status LampRemoving Jammed Media Appendix 1 Specifications A1.1 PrinterEV4D-TS14-QM-R A1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorBlack Mark Figure below shows the effective print area on the media Appendix 2 Interface Interface CablesGlossaries Bar codeSupply EO1-33088C