Toshiba B-EV4D owner manual Batch mode

Page 21

2. PRINTER SETUP

ENGLISH VERSION EO1-33088

2.7 Loading the Media

2.7Loading the Media (Cont.)

9.Close the Top Cover gently and push down the arrow-indicating portions until they click.

10.Press the [FEED] button to check for a proper media feed.

FEED Button

CAUTION!

To separate the printed media from the media roll in batch mode, be sure to tear off the media at the Media Outlet or cut the media past the Strip Plate. If you tear off the media at the Print Head by mistake, be sure to feed one label (10 mm or more) with the FEED Button prior to a next issue. Failure to do this may cause a paper jam.

There are three issue modes available for this printer.

Batch mode:

In the batch mode, the media is continuously printed and fed until the number of media specified in the issue command has been printed.

E2-10

Image 21
Contents EV4D Series Vorsicht CE Compliance for EU onlyMeanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents For EU only EA2-1Product Overview Introduction Features Unpacking AccessoriesSVT H05VV-F When purchasing the power cordDimensions Front View AppearanceRear View Interior Printer status Button and Indicator LampPrecautions Printer SetupProcedure before Operation Turning the PrinterTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord Opening/Closing the Top Cover To open the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode How to set the media Strip mode OptionCut mode Option How to Load Fanfold Paper StockExternal Media Roll Hanger Option Test, and Dump Mode different type Utilities Media SensorMedia Sensor Calibration Print test label sample Self Print Test and Dump ModeE2-16 How to Use an SD Card „ Inserting an SD Card„ Removing an SD Card Maintenance CleaningPrint Head Media Housing Platen/SensorsCover Option Care/Handling of the MediaTroubleshooting Guide TroubleshootingStatus Lamp Color Status Cause SolutionsRemoving Jammed Media A1.1 Printer Appendix 1 SpecificationsEV4D-TS14-QM-R A1.3 Media A1.2 OptionsA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaBlack Mark Figure below shows the effective print area on the media Interface Cables Appendix 2 InterfaceBar code GlossariesSupply EO1-33088C