Toshiba B-EV4D owner manual A1.2 Options, A1.3 Media, A1.3.1 Media Type, Label, Tag paper

Page 37

APPENDIX 1 SPECIFICATIONS

ENGLISH VERSION EO1-33088

A1.2 Options

A1.2 Options

Option Name

Type

Description

AC Adapter Cover

B-EV904-AC-QM-R

Attached to the printer bottom for housing the AC

 

 

adapter.

Cutter module

B-EV204-F-QM-R

A cutter unit that makes full cuts.

 

B-EV204-P-QM-R

A cutter unit that makes partial cuts.

Strip module

B-EV904-H-QM-R

When attached to the front of the Media Outlet,

 

 

this module allows the on-demand strip issue by

 

 

detecting the presence or lack of a label.

External media roll hanger

B-EV904-PH-QM-R

When this option is attached to the printer, a

 

 

media roll with an outer roll diameter up to

 

 

203mm (8”) and inner core diameter of 76.2mm

 

 

(3”) can be used.

NOTE:

The above options are available from your nearest TOSHIBA TEC representative or TOSHIBA TEC Head Quarters.

A1.3 Media

Please make sure that the media to be used is approved by TOSHIBA TEC. The warranties do not apply to problems caused by using media that is not approved by TOSHIBA TEC.

For information regarding TOSHIBA TEC-approved media, please contact a TOSHIBA TEC authorised representative.

A1.3.1 Media Type

The table below shows the size and shape of the media that can be used on this printer.

Label

Black Mark

Tag paper

Black Mark

(on reverse side)

(on reverse side)

 

g

g

 

Cut position

 

 

e

e

 

f

 

 

d

Feed Direction

h

c

 

d

 

 

c

EA1- 3

Image 37
Contents EV4D Series Vorsicht CE Compliance for EU onlyMeanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents For EU only EA2-1Product Overview Introduction Features Unpacking AccessoriesSVT H05VV-F When purchasing the power cordAppearance Dimensions Front ViewRear View Interior Printer status Button and Indicator LampPrecautions Printer SetupTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode How to set the media Strip mode OptionCut mode Option How to Load Fanfold Paper StockExternal Media Roll Hanger Option Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Print test label sample Self Print Test and Dump ModeE2-16 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Option Care/Handling of the MediaTroubleshooting Guide TroubleshootingStatus Lamp Color Status Cause SolutionsRemoving Jammed Media A1.1 Printer Appendix 1 SpecificationsEV4D-TS14-QM-R A1.3 Media A1.2 OptionsA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorBlack Mark Figure below shows the effective print area on the media Interface Cables Appendix 2 InterfaceBar code GlossariesSupply EO1-33088C