Toshiba B-EV4D owner manual Figure below shows the effective print area on the media

Page 40

APPENDIX 1 SPECIFICATIONS

ENGLISH VERSION EO1-33088 A1.3 Media

The figure below shows the effective print area on the media.

Start line

1.5mm from the left edge of media

1mm

Guaranteed print area

1mm

1.5mm from the right edge of media

Media feed direction

Media width

(Backing paper width is not included.)

NOTES:

1.Be sure not to print on the 1.5-mm wide area from the media edges (shaded area in the above figure).

2.The centre of media should be positioned at the centre of the print head.

3.Print quality is not guaranteed within 3 mm from the print head stop position (including 1-mm slow-up.)

4.Average print (black) rate should be 15% or less. For bar code print area, the print rate should be 30% or less.

5.Line weight should be 3 to 12 dots.

EA1- 6

Image 40
Contents EV4D Series CE Compliance for EU only VorsichtSafety Summary Meanings of Each SymbolPrecautions Request Regarding MaintenanceTable of Contents EA2-1 For EU onlyIntroduction Features Unpacking Accessories Product OverviewWhen purchasing the power cord SVT H05VV-FAppearance Dimensions Front ViewRear View Interior Button and Indicator Lamp Printer statusPrinter Setup PrecautionsTurning the Printer Procedure before OperationTurning on the Printer Turning OFF the Printer Connecting the Cables to the Printer Connecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Loading the Media Open the Media Holders 1 Media Sensor Calibration Batch mode Strip mode Option How to set the mediaHow to Load Fanfold Paper Stock Cut mode OptionExternal Media Roll Hanger Option Media Sensor Test, and Dump Mode different type UtilitiesMedia Sensor Calibration Self Print Test and Dump Mode Print test label sampleE2-16 „ Inserting an SD Card How to Use an SD Card„ Removing an SD Card Cleaning MaintenancePrint Head Platen/Sensors Media HousingCover Care/Handling of the Media OptionTroubleshooting Troubleshooting GuideColor Status Cause Solutions Status LampRemoving Jammed Media Appendix 1 Specifications A1.1 PrinterEV4D-TS14-QM-R A1.2 Options A1.3 MediaA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorBlack Mark Figure below shows the effective print area on the media Appendix 2 Interface Interface CablesGlossaries Bar codeSupply EO1-33088C