Toshiba TOSNIC-7000S instruction manual 3 H 1 0 0 Switch Power Supply UPS → Bypass

6 F 3 H 1 0 0 1

8.3.2 Switch Power Supply (UPS → Bypass)

Table 8.2 shows the procedure used to switch between UPS power supply and bypass power supply.

Table 8.2 UPS Power Supply → Bypass Power Supply

Step	Procedure	LCD/LED Status (After Execution)
1	Check to make sure
	power is being		UPS SUPPLY
	supplied to the UPS.
				AC-VO			200[V]
				AC- I O	50[%]
		～
			～			～		UPS
		AC INPUT	CONVERTER		INVERTER
			FLOAT CHARGE					AC	～
		BATTERIES						SWITCH
			EQUAL CHARGE
			DISCHARGE						AC OUTPUT
		～
								BYPASS
		BYPASS INPUT
2	Hold down the
	"BYPASS" key (f in		BYPASS
	Figure 6.3.1 on page
				AC-VO			200[V]
	14) for at least 0.5
				AC- I O	50[%]
	second.
				PRESS ‘UPS’ SWITCH

→The will start the

	power supply	～	～	～	UPS
	changing process.	AC INPUT	CONVERTER	INVERTER
			FLOAT CHARGE		AC	～
		BATTERIES	EQUAL CHARGE		SWITCH
			DISCHARGE			AC OUTPUT
		～			BYPASS
		BYPASS INPUT
		The “UPS” LED unlit and “BYPASS” LED lit.
3	Wait several seconds
	for the process to be		BYPASS
	completed.		AC-VO	200[V]
	→Change to bypass
			AC- I O	50[%]
	power supply is		PRESS ‘UPS’ SWITCH
	completed.
		～	～	～	UPS
		AC INPUT	CONVERTER	INVERTER
			FLOAT CHARGE		AC	～
		BATTERIES	EQUAL CHARGE		SWITCH
			DISCHARGE			AC OUTPUT
		～			BYPASS
		BYPASS INPUT

*To change from bypass to UPS power supply, use the procedure starting with Step 10 in Table 8.1 on page 30. If for some reason the AC switch dose not function, contact the

-31 -