Toshiba 1800 manual Operating Precautions

Page 14

1)Install the unit in a well ventilated location; allow at least 4 inches (10 cm) on all sides and 8 inches (20 cm) on back for air ventilation and for maintenance.

2)Install the unit in a stable, level, and upright position that is free of vibration.

3)Install the unit where the ambient temperature is between 32° and 104°F (0° and 40°C).

4)Do not install the UPS in areas that are subject to high humidity.

5)Do not install the UPS in a location that will cause direct sunlight to shine on the unit.

6)Do not install the UPS in areas that are subject to contamination such as high levels of airborne dust, metal particles, or flammable gas.

7)Avoid installation near sources of electrical noise. Always make sure that the unit earth ground is intact to prevent electrical shock and to help reduce electrical noise.

8)Do not install where water or any foreign object may get inside the UPS.

9)This UPS generates and can radiate radio-frequency energy during operation. Although RFI noise filters are installed inside the unit there is no guarantee that the UPS will not influence some sensitive devices which are operating close by. If such interference is experienced, the UPS should be installed farther away from the affected equipment and/or powered from a different source than that of the affected equipment.

Operating Precautions

Caution

1)The UPS should not be powered up until this entire manual has been reviewed.

2)The input power source voltage and frequency must be within the allowable range specified in Appendix A. Voltages and frequencies outside of the specified tolerance range may cause internal protection devices to activate.

14

1800 Series User Manual

Image 14
Contents Series Page Product Use and Warranty Restrictions Qualified Personnel only Toshiba International Corporation Toshiba’s Customer Support CenterToshiba Customer Support Center Instructions Importantes Concernant LA Sécurité Preventive Maintenance Appendix D Bypass Undervoltage / OvervoltageGeneral Safety Instructions Important Safety Instructions Instructions Importantes Concernant LA Sécurité Theory of Operation Power BackupProduct Description Application and UsePower Conditioning Inspection of the New UPS Equipment Inspection/InstallationInstallation Precautions Unpacking InstructionsOperating Precautions Layout UPS Power Connections External DimensionsWiring the Unit Power Connections 120 V Input Terminal Block DetailsPower Connections 208/240 V Input H2A H1A LOW COM HighOperating the UPS Display Panel LayoutOption Starting the UPS SystemStopping the UPS Initial Mode Resultant Mode after Switch to Bypass UPS Display Status and Operating Condition UPS Display Status and Operating Condition Battery Backup Time Battery Recharge TimeBattery Check Function Function Control ButtonCommunication Interface Remote Contacts IBM AS/400RS-232C CTSTroubleshooting Option Card SlotOver Heat 100% Flash Sound for Voltage 20% Flash Sound for Frequency 60% Flash Sound for Faults Fault Over Heat 150% Second Avoid Storage of UPS EquipmentGeneral Guidelines Before StoringDisposal Recharging requirements during storageParts Replacement Preventive and Scheduled Maintenance/Parts ReplacementPreventive Maintenance Appendix a Specifications UG1G2L024C6TBEvvironmental Physical Battery Appendix B System Overload Appendix C Parallel Operation Appendix D Bypass Undervoltage Overvoltage Appendix E 1800 Model/Wire Size Specifications Toshiba International Corporation Procedure Modifications Page Page Page Page Page Industrial Division
Related manuals
Manual 12 pages 33.79 Kb