Toshiba 1800 manual Modifications

Page 46

and/or BATTERY but in no event after the expiration of the respective warranty period. Subject to the limitations of this policy and product type, TIC service or TIC service representative shall repair/replace the UPS/part warranted here- under, without charge for material, labor. If TIC determines that the requested repair is not covered under this limited warranty policy, then TIC shall advise customer and quote cost of repair. Repair charges shall be based on service parts price and prevailing service charges at the time of repair.

If the case in process is a BATTERY (stand-alone and/or cabinet) TIC will use its published Battery Diagnostic Document to evaluate warranty applicability. First, TIC will make sure that the storage, maintenance, installation, and oper- ating conditions were met; then the BATTERY capacity will be tested in accor- dance with the “performance test” guidelines IEEE Std 450. If the BATTERY fails to deliver 70% of its rated capacity it shall be deemed defective and be replaced. Either float or cyclic service will be used to determine the warranty credit (as per published Battery Diagnostic Document). The typical credit ap- plied will be as in the following table:

Credit for Replacement Battery When Approved Warranty

Time from Shipment

UPS Batteries

Cost to Customer

(Months)

% Credit

% List Price

0-24

100

0

25-30

55

45

31-36

45

55

37-42

35

65

43-48

25

75

49-54

15

85

55-60

5

95

MODIFICATIONS

No representative, salesperson, agent, distributor, or employee of TIC is authorized to modify any of the terms of this warranty, unless modifications are made in writing and signed by an authorized TIC officer.

THIS WARRANTY REPRESENTS THE ENTIRE AGREEMENT BETWEEN TIC AND USER WITH RESPECT TO THE SUBJECT MATTER HEREIN AND SUPERSEDES ALL PRIOR OR CONTEMPORANEOUS ORAL OR WRITTEN COMMUNICATIONS, REPRESENTATIONS, UNDERSTANDINGS OR AGREEMENTS RELATING TO THIS SUBJECT.

46

1800 Series User Manual

Image 46
Contents Series Page Product Use and Warranty Restrictions Qualified Personnel only Toshiba Customer Support Center Toshiba’s Customer Support CenterToshiba International Corporation Instructions Importantes Concernant LA Sécurité Preventive Maintenance Appendix D Bypass Undervoltage / OvervoltageGeneral Safety Instructions Important Safety Instructions Instructions Importantes Concernant LA Sécurité Theory of Operation Power BackupProduct Description Application and UsePower Conditioning Inspection of the New UPS Equipment Inspection/InstallationInstallation Precautions Unpacking InstructionsOperating Precautions Layout Wiring the Unit External DimensionsUPS Power Connections Power Connections 120 V Input Terminal Block DetailsPower Connections 208/240 V Input H2A H1A LOW COM HighOperating the UPS Display Panel LayoutStopping the UPS Starting the UPS SystemOption Initial Mode Resultant Mode after Switch to Bypass UPS Display Status and Operating Condition UPS Display Status and Operating Condition Battery Backup Time Battery Recharge TimeBattery Check Function Function Control ButtonCommunication Interface Remote Contacts IBM AS/400RS-232C CTSTroubleshooting Option Card SlotOver Heat 100% Flash Sound for Voltage 20% Flash Sound for Frequency 60% Flash Sound for Faults Fault Over Heat 150% Second Avoid Storage of UPS EquipmentGeneral Guidelines Before StoringDisposal Recharging requirements during storagePreventive Maintenance Preventive and Scheduled Maintenance/Parts ReplacementParts Replacement Appendix a Specifications UG1G2L024C6TBEvvironmental Physical Battery Appendix B System Overload Appendix C Parallel Operation Appendix D Bypass Undervoltage Overvoltage Appendix E 1800 Model/Wire Size Specifications Toshiba International Corporation Procedure Modifications Page Page Page Page Page Industrial Division
Related manuals
Manual 12 pages 33.79 Kb