Toshiba 1800 manual Battery Backup Time, Battery Recharge Time

Page 24

Battery Backup Time

The exact amount of backup time provided will vary depending on the UPS model being used, number of batteries, condition of the batteries and other factors. However, the chart below gives the times that can be expected from the standard units with batteries in good condition. For longer runtime options contact your Toshiba sales representative or the Toshiba marketing department at 877-867-8773 or by e-mail at toshibaups@tic.toshiba.com.

Table 1 - Backup Time as a % of rated load*

UPS Model

100%

75%

50%

25%

1500 VA**

13 min

22 min

35 min

65 min

2000 VA**

10 min

17 min

25 min

53 min

2400 VA

7 min

12 min

20 min

44 min

*Times given are approximate and will vary depending on the age of the batteries, the battery temperature, the number of previous discharges and the type of load.

**Products are under development, specification may change.

Battery Recharge Time

The following table gives estimates of the time required to recharge the UPS’s batteries. The recharge time may vary depending on the battery temperature, the age of the batteries, and other factors.

Table 2 - Battery Recharge Time*

Unit

Batteries

1500 VA

3 ½ hours

2000 VA

3 ½ hours

2400 VA

3 ½ hours

* Recharge times are to 90% full capacity.

24

1800 Series User Manual

Image 24
Contents Series Page Product Use and Warranty Restrictions Qualified Personnel only Toshiba’s Customer Support Center Toshiba Customer Support CenterToshiba International Corporation Instructions Importantes Concernant LA Sécurité Preventive Maintenance Appendix D Bypass Undervoltage / OvervoltageGeneral Safety Instructions Important Safety Instructions Instructions Importantes Concernant LA Sécurité Power Backup Product DescriptionTheory of Operation Application and UsePower Conditioning Inspection/Installation Installation PrecautionsInspection of the New UPS Equipment Unpacking InstructionsOperating Precautions Layout External Dimensions Wiring the UnitUPS Power Connections Power Connections 120 V Input Terminal Block DetailsPower Connections 208/240 V Input H2A H1A LOW COM HighOperating the UPS Display Panel LayoutStarting the UPS System Stopping the UPSOption Initial Mode Resultant Mode after Switch to Bypass UPS Display Status and Operating Condition UPS Display Status and Operating Condition Battery Backup Time Battery Recharge TimeBattery Check Function Function Control ButtonCommunication Interface Remote Contacts IBM AS/400RS-232C CTSTroubleshooting Option Card SlotOver Heat 100% Flash Sound for Voltage 20% Flash Sound for Frequency 60% Flash Sound for Faults Fault Over Heat 150% Second Storage of UPS Equipment General GuidelinesAvoid Before StoringDisposal Recharging requirements during storagePreventive and Scheduled Maintenance/Parts Replacement Preventive MaintenanceParts Replacement Appendix a Specifications UG1G2L024C6TBEvvironmental Physical Battery Appendix B System Overload Appendix C Parallel Operation Appendix D Bypass Undervoltage Overvoltage Appendix E 1800 Model/Wire Size Specifications Toshiba International Corporation Procedure Modifications Page Page Page Page Page Industrial Division
Related manuals
Manual 12 pages 33.79 Kb