Panasonic HX-A100 owner manual How to remove the battery, Regarding the handling of used batteries

How to remove the battery

When disposing of your used products, delete personal information from this unit by initializing the network settings.

This figure describes the disposal of this unit, it is not instruction for repair. If disassembled, repair is not possible.

≥Disassemble after the battery runs out.

≥If it cannot be removed smoothly, contact Panasonic’s Service Center.

≥Keep disassembled parts out of reach of children.

1Open the side cover, and remove all of the 6 screws indicated in the

figure below.

≥Use a cross-slot screwdriver (commercially available).

2Remove the circuit board on the front side (button side) of this unit, and remove the flexible circuit board A.



3After pulling out the built-in battery connector B, pull out the flexible circuit board C, and pull out the speaker connector D upwards.



 

4Remove the 4 screws indicated in the figure below, and remove the heatsink E.



5Remove the connector F of the camera unit, and lift up the circuit board.



6Remove the battery by using a screwdriver.

Regarding the handling of used batteries

≥Insulate the terminals with cellophane tape or similar.

≥Do not disassemble.

- 62 -