Toshiba 203SD manual Memory FULL, Press Start to, Machine is in auto power shut-off

TROUBLESHOOTING AND MAINTENANCE

Problem		Cause and solution	Page
		Copying or printing is performed.
		→ Set the paper size after copying or	-
		printing is complete.
Paper size for a paper
		The machine has stopped temporarily
tray cannot be set.		due to running out of paper or a	15, 19,
		misfeed.
			70
		→ Load paper or remove the misfeed, and
		then set the paper size.
Output does not stack		Both ends of the paper are curled
		upward.
neatly in the paper			15
		→ Turning the paper over in the paper tray
output tray.
		may help.
		"MEMORY FULL, PRESS START TO
		RESUME." appears in the display.
		→ The memory became full during sort	30
A copy job stops before		copy. Copy only the originals that have
it is finished.		been scanned to that point, or cancel
		the job and clear the data from memory.
		The tray is out of paper.	15
		→ Load paper.
		Other indicators are lit.
		→ If other indicators are lit, the machine is
		in preheat mode. Press any key on the	13
		operation panel to resume normal
The power save		operation.
indicator is lit.		Only the power save indicator is lit.
		→ If only the power save indicator is lit, the	13
		machine is in auto power shut-off
		mode. Press the [START] key ( ) to
		resume normal operation.
Error indicator (	) is	See "DISPLAY MESSAGES" to check the
		meaning of the error indicator and error	61
lit or blinking.		message in the display, and take
		appropriate action.
		The same power outlet is used for the
		lighting fixture and the machine.
Lighting fixture flickers.		→ Connect the machine to a power outlet	-
		which is not used for other electric
		appliances.

66