ISA Configuration Utility Messages: Dell OptiPlex GX1
ERROR: Fatal BIOS error Internal Error Code.
Manager for it to run.
A BIOS call failed with an internal error. The most likely cause is an incompatibility between the BIOS and the Configuration Manager.
See "Getting Help" in your Diagnostics and Troubleshooting Guide for instructions on obtaining technical assistance.
ERROR: Could not read NVS, Error=Internal Error Code.
ERROR: Failed NVS write. Error=Internal Error Code.
ERROR: Failed to activate device, CSN=Card Select Number.
WARNING: Could not configure Plug and Play Card Name.
WARNING: Could not
An attempt to read the NVRAM failed.
An attempt to write to NVRAM failed.
A Plug and Play expansion card could not be activated.
The card(s) mentioned are not fully configured due to resource conflicts.
See "Getting Help" in your Diagnostics and Troubleshooting Guide for instructions.
Run the Dell Diagnostics to verify the integrity of your system NVRAM. See "Running the Dell Diagnostics" in your Diagnostics and Troubleshooting Guide for instructions.
If you are unable to determine the cause of the error, see "Getting Help" in your Diagnostics and Troubleshooting Guide for instructions.
Use the following procedure:
1.Exit the ICU and turn off your system.
2.Remove the Plug and Play expansion card that could not be activated.
Follow steps 2 through 6 of
"Removing an Expansion Card" and then return to this procedure.
3.Reinstall the Plug and Play expansion card.
Follow steps 5 through 10 of
"Installing an Expansion Card" and then return to this procedure.
If you still receive the error message, contact the manufacturer of the Plug and Play expansion card for assistance.
If you have documentation that lists the allowable resource values for your Plug and Play or PCI expansion card, you can use the following procedure to locate and resolve the resource conflict.
file:///C/infodev/2013/eDoc/OpGX1/SQRG/isa.htm[2/21/2013 11:53:05 AM]