High Availability
Select Interface → WAN1 and choose IP Setting Mode as Static or Dynamic. Click on Detect Link Status to configure the Ethernet WAN Link Detection as explained below.
Web UI
Ethernet WAN Link Detection
Interface | The WAN interface on which link detection is to be performed. |
|
|
Link Detection | Select to enable Link Detection on this Interface. |
|
|
Mode | Select protocol (ARP or ICMP) used to detect reachability of the default |
| gateway IP address. If the default gateway is reachable, then the Protocol |
| Status of the Interface will be UP, otherwise it will be DOWN. |
|
|
No of Retries | Enter the number of attempts to reach the default gateway, before |
| confirming the status (UP/DOWN) of the link. |
|
|
Delay between | Enter the time in seconds between retry attempts. |
Retries |
|
|
|
After entering all the information press the Table will display the list of interfaces on status.
Apply button. The Ethernet WAN Status which Link Detection is enabled and their
Dlink | 30 |