D-Link DRO-210i manual IPSec Tunnel or Passthrough, Peer-To-Peer, IPSec Passthrough

Page 50

Virtual Private Network

8.1 IPSec Tunnel or Passthrough

The IPSec VPN Feature can operate in 2 modes:

￿IPSec Passthrough:

In this mode, the router will allow IPSec-VPN tunnels to be established between multiple LAN side IPSec clients and multiple remote IPSec servers. It can also support multiple LAN side IPSec clients to connect simultaneously to a single remote IPSec server. But the administrator cannot establish tunnels from the router to remote IPSec peers.

￿IPSec Tunnel:

In this mode, the administrator can establish tunnels from the router to remote IPSec peers. However, IPSec Passthrough functionality will not be available in this mode.

￿ Note: The router can operate in only one of the modes at a time - either IPSec Passthrough mode or IPSec Tunnel mode.

Select VPN → VPN-IPSecto configure the VPN IPSec Configurations as explained below.

Web UI

VPN IPSec Configurations

IPSec Passthrough

Select Enable to activate the Passthrough feature.

 

 

IPSec Tunnel

Select Enable to activate the Tunnel feature.

 

 

8.2 Peer-To-Peer

In Peer-To-Peer mode, the administrator can setup a secure tunnel between the router and a remote IPSec gateway. After the tunnel is established, the networks behind both the IPSec routers can communicate securely via the internet.

￿ Note: There should not be any IP Address conflict between the LAN subnets behind the IPSec routers i.e both the LAN networks should not be in the same subnet.

Typically, the remote IPSec peer can be identified by means of its IP Address. If the peer’s IP Address can vary, then the remote peer can be identified by its Domain Name.

Select VPN → Peer-To-Peerto configure the Tunnel Configurations as explained below.

Web UI

Tunnel Configurations

Dlink DRO-210i User Guide

50

Page 49 Page 51
Image 50
Page 49 Page 51
Contents DRO-210i Table Of Contents Virtual Private Network About This Manual BoldDlink DRO-210i User Guide Product OverviewProduct Overview DRO-210i Package Contents Hardware DetailsFront Panel Rear Panel Software Features RoutingVPN Tools Disabled WAN2/DMZ Port ConfigurationOptional Port Configuration InterfacesDMZ Interface LAN SettingsLAN Interface Forgot LAN IP ?Maximum Transmission Unit DMZ SettingsWAN Interface IP Settings for WAN1 Interface Static ModeDynamic Mode Dhcp Settings for WAN1 InterfacePPPoE Mode Unnumbered InterfacesPPPoE Settings for WAN1 Interface Dhcp Server DHCP, DNS and TimeDhcp DHCP, DNS and TimeDhcp Static Mapping Dhcp Static MappingDhcp Relay Dhcp RelayDNS Proxy Settings DNS ProxySystem Time Settings TimeRouting RoutingStatic Routing Static RoutingDynamic Routing RIP Settings Routing Table Routing TablePolicy Based Routing Policy Based RoutingTo the same destination High Availability Auto BackupBackup Configuration High AvailabilityEthernet Link Detection Load Balancing ConfigurationLoad Balancing Ethernet WAN Link Detection Network Address Translation NAT Interface ConfigurationNAT Interface Configuration NATNAT Exception NAT ConfigurationNAT Configuration Virtual Server/NAPT Virtual ServerNAT Exception SIP ALG Configuration SIP-ALGNAT Table NAT Session TableFirewall Interface ConfigurationFirewall Interface Configuration Firewall PoliciesPolicy Rules Policy RulesInbound Policies Permitted ServicesInbound Policies Permitted Services Inbound PoliciesAdd Permitted IP Rule Outbound PoliciesIP Permitted Rules Outbound Policies Outbound PoliciesIP Blocked Rules Blocked ServicesOutbound Policies Service Blocked Rule Add Blocked IP RuleOutbound Policies Untrusted Domain Domain FilterUntrusted Domain Trusted DomainCookie Filter Web FilterJava Filter ActiveX FilterFile Extension Filter Keyword FilterKeyword Exception Add Blocked MAC Address MAC FilterBlocking Log Blocking Log TableIDS Configuration Intrusion DetectionIDS Configuration Intrusion Log Table Intrusion LogBlack List Black List TableVirtual Private Network Virtual Private NetworkIPSec Passthrough IPSec Tunnel or PassthroughPeer-To-Peer IPSec TunnelVirtual Private Network Same IKE Encryption algorithm on both ends of a VPN tunnel IPSec Server Configurations IPSec ServerMaximum life duration is 86400 seconds Limitation Tunnel Remote ID ConfigurationTunnel Table IPSec Status IPSec StatusIPSec Log IPSec Log TableQuality of Service Quality of ServiceClass Configuration HTB QoS ConfigurationsQuality of Service Filter Configuration QoS Filter ConfigurationsType Of Service/DiffServ TOS/DiffServQuality of Service Device Information AdministrationAdministration Device InfoTraffic Statistics Traffic StatisticsSession Log Session Log Password ChangeSysLog System LogSystem Change PasswordPassword Recovery SystemUpdate Firmware/Configuration Upload/DownloadPing Test Remote AccessRemote Access Ping TestAdministration Dlink DRO-210i User Guide General Frequently Asked QuestionsFrequently Asked Questions Q6. What is the purpose of Dhcp Server Auto Configuration? DHCP, DNSRouting High AvailabilityFirewall Frequently Asked Questions 11.6 NAT Q21. What are the call features supported by SIP-ALG? 11.7 VPN11.8 QoS Frequently Asked Questions

DRO-210i specifications

The D-Link DRO-210i is an innovative smart security camera designed to bring peace of mind to homeowners and businesses alike. With its sleek design and advanced features, the DRO-210i stands out as a reliable surveillance solution that caters to a range of security needs.

One of the main features of the DRO-210i is its high-definition video streaming capability. With a resolution of up to 1080p, users can enjoy crisp and clear video footage, ensuring that every detail is captured. This camera is equipped with a wide-angle lens, offering a 130-degree field of view, which allows for comprehensive monitoring of large areas, making it ideal for both indoor and outdoor use.

The DRO-210i utilizes advanced infrared night vision technology, enabling it to capture clear images even in complete darkness. This feature ensures that security is maintained 24/7, offering peace of mind regardless of lighting conditions. The camera automatically switches to night mode when it detects low light, ensuring continuous monitoring without manual intervention.

Another standout characteristic of the DRO-210i is its motion detection capabilities. The camera features customizable motion zones and alerts, allowing users to define specific areas for monitoring. When motion is detected, the camera can send real-time alerts to the user's smartphone or email, ensuring prompt responses to any potential security threats.

The integration of two-way audio allows for real-time communication through the camera. Users can listen and speak through the camera's built-in speaker and microphone, providing an added layer of security. This feature is particularly useful for engaging with visitors or deterring potential intruders.

For convenient storage options, the DRO-210i supports both local and cloud storage. Users can insert a microSD card for local recording or opt for D-Link’s cloud storage service for easy and secure access to footage from anywhere in the world. This flexibility ensures that important recordings are safely stored and easily retrievable.

The camera's compatibility with smart home systems is an essential aspect of its design. The DRO-210i works seamlessly with various smart home ecosystems, allowing users to integrate it into their existing setups, enhancing their overall smart home experience.

In summary, the D-Link DRO-210i is a feature-rich, user-friendly security camera equipped with high-definition video, night vision, motion detection, two-way audio, and flexible storage options. Its compatibility with smart home technologies makes it an ideal choice for those seeking a comprehensive surveillance solution that not only enhances security but also integrates with their lifestyle.
Top Page Image Contents