Actiontec electronic IS560LH Range Default Unitsseconds, Connection Completion Time-Out

nous only. The modem will not recognize the backspace character if it is set to a value that is greater than 32 ASCII. This character can be used to edit a command line. When the echo command is enabled, the modem echoes back to the local DTE the backspace character, an ASCII space character, and a second backspace character. This means a total of three characters are transmitted each time the modem processes the backspace character.

S6 Wait Before Dialing

Range: 2-65

Default: 2

Units:seconds

This register sets the length of time, in seconds, that the modem must wait (pause) after going off-hook before dialing the first digit of the telephone number. The mo- dem always pauses for a minimum of two seconds, even if the value of S6 is less than two seconds. The wait for dial tone call progress feature (W dial modifier in the dial string) will override the value in register S6. This operation, however, may be affected by some ATX options according to country restrictions.

S7 Connection Completion Time-Out

Range: 1-255

Default: 50

Units:seconds

This register sets the time, in seconds, that the modem must wait before hanging up because carrier is not detected. The timer is started when the modem finishes dialing (originate), or goes off-hook (answer). In originate mode, the timer is reset upon detection of an answer tone if allowed by country restriction. The timer also specifies the wait for silence time for the @ dial modifier in seconds. S7 is not associated with the W dial modifier.

S8 Comma Dial Modifier Time

Range: 0-65

Default: 2

Units:seconds

This register sets the time, in seconds, that the modem must pause when it encoun- ters a comma (“,”) in the dial command string.

67