Airlink manual Host RJ-11 IP Gateway Defaults, Configuring the Host RJ-11 IP Gateway

Installation

Note: When you have completed configuring the Host RJ-11 IP Gateway, you will want to reconfigure the IP address on your computer to how it was configured before you started these steps. Use the directions in this step to reset the configura- tion.

Configuring the IP Address and Interface Port of the Host RJ- 11 IP Gateway

Host RJ-11 IP Gateway Defaults

•Phone port: 8 data bits, no parity, and 1 stop bit (8N1).

•Protocol: American/Bell 212A.

•Maximum baud: 2400.

•DHCP client: disabled.

•IP Address: 192.168.1.3.

Note: If you are using the defaults for the Host RJ-11 IP Gateway, you can skip this section and connect your Host RJ-11 IP Gateway directly to your device and net- work.

	Configuring the Host RJ-11 IP Gateway
1.	Connect the Host RJ-11 IP Gateway to power and connect the Ethernet cable from your computer
	to the Host RJ-11 IP Gateway.
2.	Type “http://192.168.1.3:9080” (see the example in the screenshot below) in the Address or
	Location bar and press the enter key.

FIGURE 10. Web Browser : Enter the Location

http:192.168.1.3:9080

Since many cellular carriers block the standard web browser ports (80 and 8080), the Host RJ-11 IP Gateway uses 9080 by default as the port for the web-based interface.

The web-based interface will open. On the left side of the window are menu options. The central area of the window is the working area (shown in the close up screen shots for the configuration settings).

Host RJ-11 IP Gateway User Guide, version 12