Airlink Configuring your Raven-E for the Host RJ-11 IP Gateway, Installation, Default settings

Installation

If you will be connecting the Host RJ-11 IP Gateway to a Raven-E, you will need a cross-over Ethernet cable to configure your Raven-E unless your computer’s Ethernet port is auto-sensing.

The Host RJ-11 IP Gateway has an auto-sensing Ethernet port, you can use either a cross-over cable or a straight-through Ethernet cable to connect the Host RJ-11 IP Gateway to the Raven-E or your computer.

•Power supplies and a power source - You will need a power supply and power source for both the Host RJ-11 IP Gateway and the Raven-E (as applicable).

•PC or Laptop - To configure both the Host RJ-11 IP Gateway and the modem (as applicable), you will need a computer with Internet Access, other than the cellular account, and an available Ethernet port.

Cellular Account Required

•Cellular Account - If you will be connecting the Host RJ-11 IP Gateway to a Raven-E, you need to already have an active account with a cellular provider and to have activated your modem with that provider. The AirLink Raven-E is certified to work with a variety of cellular providers.

If you need to activate your modem, you can use the Setup Wizard for your cellular provider which you can obtain from the AirLink website: http://www.airlink.com/support/.

Important Information about Ports

•Port Blocking - Many cellular providers and other ISPs block ports below 1024 which are the default ports for many server protocols (such as HTTP, telnet, and SSH). If your provider blocks these ports, you will need to configure a port you can access.

Configuring your Raven-E for the Host RJ-11 IP Gateway

These steps are just a basic configuration to get you started and allow the Raven-E to connect with the Host RJ-11 IP Gateway. Refer to the modem user guide for more configuration options for spe- cific environments.

Omit this section if you are not connecting your Host RJ-11 IP Gateway to a

Raven-E.

Default settings

•Management Interface IP Address: 192.168.13.31.

•Telnet and Wireless Ace password: 12345

•DHCP server: enabled.

•Public Mode - the IP Address assigned by the carrier is assigned to the Host RJ-11 IP Gateway.

Note: If you are intending to use the Host RJ-11 IP Gateway default IP Address of 192.168.1.3, you will need to change the default configuration of the Raven-E.

Host RJ-11 IP Gateway User Guide, version 6