Airlink manual AT Commands, Host RJ-11 IP Gateway User Guide, version

AT Commands

Command	Function		Response
Sn=mm	Set register to specified value (page 42)		OK(0)
Sn?	Return current value formatted as 3		Varies
	digit decimal
Vn	Result Code Format
	0=Numerical result codes		0
	1=Verbose result codes (default)		OK
Xn	Result Code Format		OK(0)
	0=“CONNECT” upon entering online
	data state
	1-4=“CONNECT <text>” upon enter-
	ing online data state
Zn	Load factory default settings		OK(0)
&Cn	DCD Control		OK(0)
	0=DCD always on
	1=DCD follows connection status
&Dn	DTR Control		OK(0)
	0=ignore
	1=loss of DTR switches to command
	mode and leaves connection open
	2=loss of DTR switches to command
	mode and closes connection (default)
&F	Load factory default settings		OK(0)
&Fn			Equivalent to ATZ without dropping the con-
			nection. This command does not affect the flash
			configuration for the port.
&V	Display S-register values		Example:
&V0			E0 Q1 V0 &C1 &D2
			S00:002 S02:043 S03:013 S04:010 S05:008
&V1	Status		Returns reason for the last disconnect:
			TERMINATION REASON......DTR LOSS
			TERMINATION REASON….CARRIER LOSS
&W	Write current configuration to flash		OK(0)
&W1
&Xnnn	Change baud rate.		OK(0)
	nnn	Baud
	3	300
	12	1,200
	24	2,400
	48	4,800
	96	9,600
	14	14,400
&X	Any other & command is ignored		OK(0)

Host RJ-11 IP Gateway User Guide, version 41