Airlink RJ-11 manual Hardware, Connectors and Reset button, Status LEDs

CHAPTER 3

Hardware

Designed for simplicity, the Host RJ-11 IP Gateway hardware has few complicated parts.

Connectors and Reset button

The Reset button is recessed. To reset the connection, using an unbent paperclip or other narrow, blunt tip, press and quickly release the reset button. To reset the configuration to the factory default, press and hold the reset button until you see the appropriate alternating light sequence.

FIGURE 1. Right side: RJ-45 connector, Power connector, and Reset button (not to scale)

ResetPower

RJ-45 Ethernet

FIGURE 2. Left side: RJ-11(phone) connector (not to scale)

RJ-11

Caution: The Host RJ-11 IP Gateway's RJ-11 phone port should never be con- nected into the Public Switched Telephone Network (PSTN). This device is designed to emulate the PSTN for other devices. The Host RJ-11 IP Gateway may sustain damage not covered by warranty if it is connected to the Public Switched Telephone Network.

Status LEDs

The top panel of the Host RJ-11 IP Gateway displays the status LEDs.

Host RJ-11 IP Gateway User Guide, version 16