Agilent Technologies E6701A manual Determine PC IP address

Page 13

4.Choose the Network and Dial-up Connections icon

a.Select the Local Area Connection icon

b.Select Properties

c.Highlight “Internet Protocol (TCP/IP)”

d.Select Properties

e.Select “Use the following IP Address”

f.Enter the PC’s IP address as provided by your Network Administrator.

g.In the Subnet Mask: field, we recommend you set the PC’s subnet mask to 255.255.255.0

h.Select OK, then OK again to exit the Network menu

Determine PC IP address

If your PC was already connected to the network, you must determine your PC’s IP Address.

1.For Windows 98, go to Windows Start, then Programs, then choose the MS-DOS Prompt icon. (For Windows 2000, go to Windows Start, then Programs, then Accessories, then choose the Command Prompt icon).

2.On the MS-DOS command line, enter “ipconfig”.

Displayed results will vary depending upon your PC’s configuration. If multiple Ethernet adapters are displayed, locate your active Ethernet LAN adapter by its title.

3.Write the Ethernet adapter’s address here:

PC’s pre-assigned IP address: ___________________________

If multiple adapters are displayed, the other IP addresses should be listed as 0.0.0.0. If they are not, refer to Appendix B: Troubleshooting.

4. Close the MSDOS window.

 Copyright 2002 Agilent Technologies.	10001810-E6701A Tutorial LAN Connection
All Rights Reserved.	Page 13 of 32	Rev. 1.2; Feb. 14, 2002

Image 13

Contents Page Table of Contents Appendix B Troubleshooting Appendix C. Glossary Appendix a Installing a WAP Gateway into a PCIntroduction About This TutorialEquipment Required for this Tutorial Normal LAN Cable Quantity Setup Test Set Setup Network SetupLAN Addresses Set the RF In/Out Amplitude Offset Set the Date and Time OptionalSet the Cell and Call Parameters Windows 98 and Dhcp Address PC SetupWindows 98 and Static Address Page Windows 2000 and Dhcp Address Set up NetworkWindows 2000 and Static Address Determine PC IP address Verify PC Settings On the WAP Settings menu, scroll to 1Primary IP Set Up Your Wireless DeviceVerify that Your Device Will Perform an Attach Motorola Timeport phone exampleSet the Device’s Primary Port On the WAP Settings menu, scroll to 2Primary PortSet Data Bearer to Gprs Set WAPlite Gateway Address in Your DeviceSetup is now complete Product Feature Protocol Logging Product Feature Screen Image CaptureHere are some important points about the log data Save the Log to the PC View the log data on the PCView the saved log Log Data Using the Test Set’s Front PanelPinging the DUT the phone or wireless device Product Feature PingPinging an Alternate Device such as your PC on the LAN If your LAN does not use a firewall to access the Internet Product Feature Data ChannelMotorola Example Scroll to http//local/waplite.wmlMotorola Timeport Example Product Feature Additional Connection Parameters Infinite WAPLite Gateway by Captaris Inc Appendix a Installing a WAP Gateway into a PCTo download the WAPlite software To load the WAPlite software on your PCIf the wireless device will not attach, check that Appendix B TroubleshootingIf Bler mode measurements have problems If Internet Explorer cannot access the 8960 Welcome Etsi Test Mode measurements have problemsBER measurement errors Phone can’t access browse real Internet sitesPhone won’t transmit IP datagrams in Data Channel functions Page Appendix C. Glossary