Agilent Technologies E6701A manual Table of Contents

Page 2

Table of Contents
Table of Contents			2
About This Tutorial			4
Introduction			4
Equipment Required for this Tutorial			5
Test Set			5
Wireless Device			5
Personal Computer (PC)			5
WAP Gateway software (for data connection evaluations)			5
Cables			5
Setup			7
Hardware Connections			7
Figure 1. PC Connected Directly to Test Set via LAN Crossover Cable			7
Test Set Setup			8
Set the Date and Time (Optional)			9
Set the RF In/Out Amplitude			9
Set the Cell Parameters			9
PC Setup			10
Windows 98			10
Windows 2000			12
Verify PC Settings			14
Verify that Your Device Will Perform an Attach			15
Set Up Your Wireless Device			15
Set WAPlite Gateway Address in Your Device			16
E6701A Features Using a Direct Connection Between the PC and Test Set			18
Product Feature: Screen Image Capture			18
Product Feature: Protocol Logging			18
View the log data on the PC			19
Save the Log to the PC			19
View the saved log			20
Log Data Using the Test Set’s Front Panel			20
Product Feature: Ping			21
Product Feature: Data Channel			23
To run the Infinite WAPlite Proxy Gateway software on your PC:			23
To access a simple local file on the WAPLite gateway with the phone:			24
To browse “real” websites via the WAPLite gateway with the phone:			24
To log the IP datagrams while you browse the WAPLite gateway with the phone:			25
Product Feature: Additional Connection Parameters			26
 Copyright 2002 Agilent Technologies.	10001810-E6701A Tutorial LAN Connection
All Rights Reserved.	Page 2 of 32	Rev. 1.2; Feb. 14, 2002

Image 2

Contents

Page Table of Contents Appendix a Installing a WAP Gateway into a PC Appendix B Troubleshooting Appendix C. GlossaryAbout This Tutorial IntroductionEquipment Required for this Tutorial Normal LAN Cable Quantity Setup LAN Addresses Network SetupTest Set Setup Set the Cell and Call Parameters Set the Date and Time OptionalSet the RF In/Out Amplitude Offset Windows 98 and Static Address PC SetupWindows 98 and Dhcp Address Page Windows 2000 and Static Address Set up NetworkWindows 2000 and Dhcp Address Determine PC IP address Verify PC Settings Verify that Your Device Will Perform an Attach Set Up Your Wireless DeviceOn the WAP Settings menu, scroll to 1Primary IP Motorola Timeport phone exampleSet Data Bearer to Gprs On the WAP Settings menu, scroll to 2Primary PortSet the Device’s Primary Port Set WAPlite Gateway Address in Your DeviceSetup is now complete Here are some important points about the log data Product Feature Screen Image CaptureProduct Feature Protocol Logging View the log data on the PC Save the Log to the PCLog Data Using the Test Set’s Front Panel View the saved logProduct Feature Ping Pinging the DUT the phone or wireless devicePinging an Alternate Device such as your PC on the LAN Product Feature Data Channel If your LAN does not use a firewall to access the InternetScroll to http//local/waplite.wml Motorola ExampleMotorola Timeport Example Product Feature Additional Connection Parameters To download the WAPlite software Appendix a Installing a WAP Gateway into a PCInfinite WAPLite Gateway by Captaris Inc To load the WAPlite software on your PCIf Bler mode measurements have problems Appendix B TroubleshootingIf the wireless device will not attach, check that Etsi Test Mode measurements have problems If Internet Explorer cannot access the 8960 WelcomePhone won’t transmit IP datagrams in Data Channel functions Phone can’t access browse real Internet sitesBER measurement errors Page Appendix C. Glossary