Agilent Technologies E6701A manual Pinging an Alternate Device such as your PC on the LAN

Page 22

9.Press Stop Ping (F3) key

10.If you started a protocol log, stop it and look at the data.

Pinging an Alternate Device (such as your PC on the LAN)

Note: You cannot log an Alternate Device Ping because the data does NOT travel through the RF link, but only via the LAN. The Protocol Logging feature only captures data that passes over the RF link.

1.Press the Ping Setup (F1) key

2.In the Ping Setup table, set the Device to Ping to Alternate

3.In the Ping Setup table, scroll to Alternate Ping Address, and press the knob.

4.Under Value, enter the PC’s LAN IP Address. Do not enter leading zeros.

5.Press the knob.

6.Press Start Ping (F3) key. It may take a moment for the PC to respond. A correct response looks like the image below. This indicates a functioning IP connection exists

between the Test Set and the PC.

7.Press Stop Ping (F3) key

8.On the Test Set, at the bottom of the display, note the Summary Results data from the ping.

 Copyright 2002 Agilent Technologies.	10001810-E6701A Tutorial LAN Connection
All Rights Reserved.	Page 22 of 32	Rev. 1.2; Feb. 14, 2002

Image 22

Contents Page Table of Contents Appendix a Installing a WAP Gateway into a PC Appendix B Troubleshooting Appendix C. GlossaryAbout This Tutorial IntroductionEquipment Required for this Tutorial Normal LAN Cable Quantity Setup Test Set Setup Network SetupLAN Addresses Set the RF In/Out Amplitude Offset Set the Date and Time OptionalSet the Cell and Call Parameters Windows 98 and Dhcp Address PC SetupWindows 98 and Static Address Page Windows 2000 and Dhcp Address Set up NetworkWindows 2000 and Static Address Determine PC IP address Verify PC Settings Verify that Your Device Will Perform an Attach Set Up Your Wireless DeviceOn the WAP Settings menu, scroll to 1Primary IP Motorola Timeport phone exampleSet Data Bearer to Gprs On the WAP Settings menu, scroll to 2Primary PortSet the Device’s Primary Port Set WAPlite Gateway Address in Your DeviceSetup is now complete Product Feature Protocol Logging Product Feature Screen Image CaptureHere are some important points about the log data View the log data on the PC Save the Log to the PCLog Data Using the Test Set’s Front Panel View the saved logProduct Feature Ping Pinging the DUT the phone or wireless devicePinging an Alternate Device such as your PC on the LAN Product Feature Data Channel If your LAN does not use a firewall to access the InternetScroll to http//local/waplite.wml Motorola ExampleMotorola Timeport Example Product Feature Additional Connection Parameters To download the WAPlite software Appendix a Installing a WAP Gateway into a PCInfinite WAPLite Gateway by Captaris Inc To load the WAPlite software on your PCIf the wireless device will not attach, check that Appendix B TroubleshootingIf Bler mode measurements have problems Etsi Test Mode measurements have problems If Internet Explorer cannot access the 8960 WelcomeBER measurement errors Phone can’t access browse real Internet sitesPhone won’t transmit IP datagrams in Data Channel functions Page Appendix C. Glossary