Agilent Technologies E6701A manual Equipment Required for this Tutorial

Page 5

Equipment Required for this Tutorial

Test Set

Agilent E5515B Opt. 002 or E5515C Opt. 002 or E5515TU Opt. 002 (upgraded)

If unit is E5515B, check serial number for compatibility: Serial number with US prefix must be ≥ US40410511 Serial number with GB prefix must be ≥ GB40410348

Contact Agilent for E5515B upgrade information if you have a lower serial number.

E6701A GPRS Lab Application (Test Set internal software; Rev. A.01.10 or higher)

E1960A GSM Test Application (optional Test Set software; useful when testing wireless devices with both GSM and GPRS capabilities; procedures using the E1960A TA are NOT included in this tutorial)

Wireless Device

GPRS phone or other wireless appliance

This tutorial was written using a Motorola Timeport 260 Series GPRS Mobile Phone with RF cable, battery, battery charger

SIM Card (Subscriber Identity Module): Use a card appropriate for your device.

Personal Computer (PC)

Windows PC

PC Hardware: Ethernet LAN port

PC Operating System:

Microsoft Windows 98 or

Windows NT, Version 4.0 with Service Pack 5 or higher (other operating systems may work, but they are not supported)

Web Browser: Microsoft Internet Explorer (Version 5.0) Other browsers may work, but require the following features:

-Support for nested frames

-Support for JavaScript (Version 1.2 or higher)

-Support for tables

WAP Gateway software (for data connection evaluations)

The following has been tested by Agilent, but is not endorsed or guaranteed by Agilent. See Appendix A for download instructions.

Infinite WAPLite Gateway (Captaris Inc.)

Cables

RF Cable

 Copyright 2002 Agilent Technologies.	10001810-E6701A Tutorial LAN Connection
All Rights Reserved.	Page 5 of 32	Rev. 1.2; Feb. 14, 2002

Image 5

Contents Page Table of Contents Appendix B Troubleshooting Appendix C. Glossary Appendix a Installing a WAP Gateway into a PCIntroduction About This TutorialEquipment Required for this Tutorial Normal LAN Cable Quantity Setup LAN Addresses Network SetupTest Set Setup Set the Cell and Call Parameters Set the Date and Time OptionalSet the RF In/Out Amplitude Offset Windows 98 and Static Address PC SetupWindows 98 and Dhcp Address Page Windows 2000 and Static Address Set up NetworkWindows 2000 and Dhcp Address Determine PC IP address Verify PC Settings On the WAP Settings menu, scroll to 1Primary IP Set Up Your Wireless DeviceVerify that Your Device Will Perform an Attach Motorola Timeport phone exampleSet the Device’s Primary Port On the WAP Settings menu, scroll to 2Primary PortSet Data Bearer to Gprs Set WAPlite Gateway Address in Your DeviceSetup is now complete Here are some important points about the log data Product Feature Screen Image CaptureProduct Feature Protocol Logging Save the Log to the PC View the log data on the PCView the saved log Log Data Using the Test Set’s Front PanelPinging the DUT the phone or wireless device Product Feature PingPinging an Alternate Device such as your PC on the LAN If your LAN does not use a firewall to access the Internet Product Feature Data ChannelMotorola Example Scroll to http//local/waplite.wmlMotorola Timeport Example Product Feature Additional Connection Parameters Infinite WAPLite Gateway by Captaris Inc Appendix a Installing a WAP Gateway into a PCTo download the WAPlite software To load the WAPlite software on your PCIf Bler mode measurements have problems Appendix B TroubleshootingIf the wireless device will not attach, check that If Internet Explorer cannot access the 8960 Welcome Etsi Test Mode measurements have problemsPhone won’t transmit IP datagrams in Data Channel functions Phone can’t access browse real Internet sitesBER measurement errors Page Appendix C. Glossary