3Com WL-560 manual Securing the Locking Bar

Page 19

Deciding Where to Place the Bridge 13

2Push the locking bar through the opening until the hole on the locking bar is exposed.

3Insert a lock through the hole on the locking bar, and then close the lock to secure it in place, as shown in Figure 7.

Figure 7 Securing the Locking Bar

		100	10
	11g		.
11a	11g	.
11a	.
	.
.

Placing the Bridge on The Bridge comes with four rubber feet that can be used to install the a Flat Surface Bridge on a flat surface such as a table or desktop.

CAUTION: Do not place the Bridge on any type of metal surface. Select a location that is clear of obstructions and provides good reception.

Remove the backing from the rubber feet and attach them to the bottom of the cradle. After the rubber feet are installed, place the Bridge on a flat surface.

Image 19

Contents 3Com 11a/b/g Wireless Workgroup Bridge User Guide 3Com Corporation Campus Drive Marlborough MA USA Contents Configuring the Bridge END User License Agreement Regulatory Information Page About this Guide Following ConventionsRelated DocumentationDocumentation documentation Product Registration Support Introduction 802.11g 802.11aPlanning ConfigurationNetwork Configuration and Planning NetworkWorkgroup Ad-Hoc Network ConfigurationsWireless Infrastructure Network ExampleBridge UnpackingBridge Wall-Mounting the Bridge Deciding Where to Place the BridgeRouting Cable Under the Cradle Securing the Locking Bar Connecting the Power ConnectingConnecting the Bridge About the Client List Connecting to a HubNetwork printers in areas that are not wired for Ethernet LED IndicatorsDetermining if you Need to ConfigureAttaching An External AntennaNetworks without a Dhcp Server Determining if you Need to Configure the BridgeTo Wireless Client Infrastructure Bridge Default SettingsUsing the 3Com Installation CD Using the 3Com Installation CDInstalling the Bridge Configuring the Bridge Device Manager Using the 3ComWireless InfrastructureUsing the 3Com Wireless Infrastructure Device Manager Click ConfigureButton Description Management UsingSystem Moving to a new configuration Clearing Applying System Configuration SettingsSystem Properties Apply Server, select Obtain an IP address automatically and clickSelect 802.11a to set the Bridge to operate with either Select Wireless Client Infrastructure to associate with anSelect Specify the Wireless LAN Service Area to allow Service AreaBeing used, click Long Wi-Fi Interoperable External and one internal antenna this settingSet the Data Preamble 40/64-bit Shared Key WEP No Security Open System128/152-bit Shared Key 104/128-bit Shared KeyAES Or DisableSecondary Radius Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart SettingsReset Applying SettingsOr with the Bridge out of the cradle Under Tools, click Restore Factory DefaultsUsing Tftp Using FTP defaultUnder Tools, click Backup Wireless Workgroup Bridge Using HttpUnder Tools, click Restore Wireless Workgroup Bridge Summary Page Diagnosing ProblemsTroubleshooting Disconnecting the Bridge DisconnectingUninstalling Uninstall 3Com Wireless Infrastructure Device ManagerFirmware Upgrading BridgeProduct to Gain Service BenefitsSolve Problems Register YourPurchase Extended WarrantyProfessional Services Access SoftwareContact Us Directory of 3Com resources by region atLatin America Telephone Technical Support and Repair END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Industry Canada IC Emissions Compliance Statement Europe EU Declaration of Conformity Bipt Indoor/Outdoor