3Com WL-560 manual Click Configure, Using the 3Com Wireless Infrastructure Device Manager

Page 31

Using the 3Com Wireless Infrastructure Device Manager 25

Devices in a different subnet than your computer are identified with exclamation points (!). You can refresh this display by clicking Refresh. You should refresh the display, for example, after you change a device IP address.

Figure 14 Wireless Infrastructure Device Manager Wireless Network Tree

2In the Wireless Network Tree, select the device you want to configure.

If more than one wireless LAN device appears in the tree and you are not sure that you have selected the right one, click Properties and check the MAC address to verify that it is the one you want.

3Click Configure.

If the selected device is on the same subnet as your computer, the Configuration Management System main page appears in your Web browser. See “Using the Configuration Management System” on page 27, for details.

If the selected device is on a different subnet, the device manager helps you to assign an IP address on the same subnet as your computer, as shown in Figure 15. You may accept the address offered or enter an address and click Next.

Image 31
Contents 3Com 11a/b/g Wireless Workgroup Bridge User Guide 3Com Corporation Campus Drive Marlborough MA USA Contents Configuring the Bridge END User License Agreement Regulatory Information Page About this Guide Following ConventionsRelated DocumentationDocumentation documentation Product Registration Support Introduction 802.11g 802.11aPlanning ConfigurationNetwork Configuration and Planning NetworkWorkgroup Ad-Hoc Network ConfigurationsWireless Infrastructure Network ExampleBridge UnpackingBridge Wall-Mounting the Bridge Deciding Where to Place the BridgeRouting Cable Under the Cradle Securing the Locking Bar Connecting the Power ConnectingConnecting the Bridge About the Client List Connecting to a HubNetwork printers in areas that are not wired for Ethernet LED IndicatorsDetermining if you Need to ConfigureAttaching An External AntennaNetworks without a Dhcp Server Determining if you Need to Configure the BridgeTo Wireless Client Infrastructure Bridge Default SettingsUsing the 3Com Installation CD Using the 3Com Installation CDInstalling the Bridge Configuring the Bridge Device Manager Using the 3ComWireless InfrastructureUsing the 3Com Wireless Infrastructure Device Manager Click ConfigureButton Description Management UsingSystem Moving to a new configuration Clearing Applying System Configuration SettingsSystem Properties Apply Server, select Obtain an IP address automatically and clickSelect 802.11a to set the Bridge to operate with either Select Wireless Client Infrastructure to associate with anSelect Specify the Wireless LAN Service Area to allow Service AreaBeing used, click Long Wi-Fi Interoperable External and one internal antenna this settingSet the Data Preamble 40/64-bit Shared Key WEP No Security Open System128/152-bit Shared Key 104/128-bit Shared KeyAES Or DisableSecondary Radius Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart SettingsReset Applying SettingsOr with the Bridge out of the cradle Under Tools, click Restore Factory DefaultsUsing Tftp Using FTP defaultUnder Tools, click Backup Wireless Workgroup Bridge Using HttpUnder Tools, click Restore Wireless Workgroup Bridge Summary Page Diagnosing ProblemsTroubleshooting Disconnecting the Bridge DisconnectingUninstalling Uninstall 3Com Wireless Infrastructure Device ManagerFirmware Upgrading BridgeProduct to Gain Service BenefitsSolve Problems Register YourPurchase Extended WarrantyProfessional Services Access SoftwareContact Us Directory of 3Com resources by region atLatin America Telephone Technical Support and Repair END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Industry Canada IC Emissions Compliance Statement Europe EU Declaration of Conformity Bipt Indoor/Outdoor